GL-01TI

Well made optics adapter plate for my gen 3 G20. Installed with ease using a rear sight tool. The plate is super solid and provides a seamless mount for my BFF3.

This is my second purchase of red dot mount for my glock 19. The first time I bought a $15 mount but it started to loose after about 50 rounds. I think the design is not strong enough because the dovetail and mount blocks are installed apart. Then I found this one-piece design mount. I look at the description and reviews, all the reviews are very good except one that makes me very confused. That review said this mount sits above the slide. I consulted the seller and they told me that the design could not eliminate the gap between plate and top of the slide, but it could be minimized. All products now have a tighter dovetail design that minimizes the gap. They also told me that if I was worried about the firmness of the mount after the installation, I could use a rubber hammer to hit it casual. If there is any damage or looseness, they will send me a new one. Of course, I will not do this. I am afraid that will be damaged my slide, lol!!! They did a great job on new products, fits very well. It took me about 5 minutes to install, very easy to install. Now hundreds of rounds through it, very sturdy, I am very satisfied.

I got this to install a Vortex Viper on my Glock pistol. It came with an assortment of screws and a couple small allen wrenches - everything needed. It's a precision-machined piece; slid into place and fits flush against the top of the slide. There are less expensive alternatives, but I'm happy I went with the DPP. Recommended.

This mount, unlike the one for the RMR footprint, works very well. I like how it is one solid piece, though on mine the dovetail section is not cut as shown in the product images. As I have a rear sight pushing tool, installation was pretty easy. Also unlike the RMR cut mount, this one doesn't have the rear of the mount raised so high especially when the stabilization screws are added to secure the mount to the slide. The only reason I am not still using this mount is because I have switched to the DBTAC mount that has the iron sight backups built into the mount. That and I upgraded from the TruGlo TruTech to a Holosun 508t. Recommend this mount if backup iron sights are not desired. Mount is solidly built.

A little space between the slide and the mount, but the installation is solid and mounted a Burris fast fire 3 and it is supper tight!

I have a Glock 19 gen 4 non mos. I bought this thinking it would fit my holosun 407 a which is the same size as the 407c. It does not fit.

This dovetail mount hold my Vortex Venom red dot very securely on my 22 year old Gen 3 Glock 26. It is a very tight fit when installing it. I used a sight pusher, and it was still a very tight fit. I can't imagine trying to use a nylon hammer to set it in place. 100 rounds and the sight was still locked in on the barrel. I miss having the use of the rear sight, and it will require practice drawing my handgun and bringing it up at the right angle so that I immediately see the red dot. Since the site sits higher than it should, I don't initially see the red dot on my reflex draw because of the angle created by the sight being higher above the slide. But much cheaper than having my slide cut.

Build quality seems fine. But does not fit the Vortex Venom as advertised.