Gikfun200pcs 2.54mm Standard Computer Jumper Caps Short Circuit Cap Mini Micro Jumper Bridge Plug DIY Kit for Arduino (Pack of 200pcs) EK1928

Fits fine

This is a maker's lifetime supply of jumpers. They install easily as well as cleanly. They also have a low profile that allows them to be installed on headers that will have another pcb sitting over them. In other words, the installed hight over pins is less than the hight of a female header. I'm using these for step selection on a Cnc Shield stepper motor driver. Also a cheap signal generator for waveform selection where they are also working as expected.

Work well, nice fit, not too loose. Will buy again when i run out!

The product is OK although the jumper plastic is rather brittle.Typical Amazon packaging was terrible. I also ordered two 625 sheet reams of 24# paper, being about 7.5#/625 sheets. Amazon shipping decided to place the little clear and hard plastic box with these jumpers in the same cardboard box WITH NO PACKING. Of course, the two 7.5 pound reams of paper shifting around in the oversized cardboard box totally smashed the jumper's plastic case, scattering them inside the cardboard box.Come on Amazon, think about how your packaging department is placing "compatible" and "non-compatible" items in the same box.

A lot of items for not too high cost

Worked as expected. No issues. Great vendor

These small 2 pin jumpers for a computer board are not easy to find. The 4 different colors can be used to highlight a specific area on a board or use them to add more interest that jus the basic black ones. Box of 100 should last you for many years. I needed them for an Arduino Shield for stepper motor controlling.

Item are as the listing says. They come in handy if your into electronics where jumpers are required