SenaSMH-A0302 Helmet Clamp Kit with Boom and Wired Microphones for SMH10 Bluetooth Headset, Black

Has everything to mount on a helmet, works good for the generation of these head sets.

I paired the SMH-A0302 kit with the SMH10 module. There are You-tube videos on how to install/glue to a Schubert C3, and my installation went easily. I doubt the whole installation took longer than 10-15 minutes. (There is a whole where the left chin strap inserts to the left chin pad. I fed the microphone through the hole and positioned it just under the fabric. You cannot see it or feel it, but people hear me perfectly.) In short, the product is incredible! After turning on, I simply speak as if I were speaking to my iPhone (which is somewhere else on my motorcycle or in my pocket) and ask to start Audible (where I listen to books on tape). I can then tap the button and simply say "call wife" and it dials. I hear perfectly at 65 mph, as does the person I'm speaking with. Previously, I had to use an amplifier to hear the books on tape from the iPhone to large and expensive speakers I put inside the helmet. This does not need an amplifier --- it fact, I had to turn down the volume. I have not tried all the features yet, but even if this is all it does, I am very, very pleased.

These are excellent

I have a tree service company and this is a must have for communication between a climber and a ground crew!! East to install on a climbing helmet and east to link helmets together. I was skeptical on being able to hear with all the noise on the job and this product out did my expectations!!!

It worked perfectly when attaching my smh-10 and putting it on my helmet. The speakers aren't amazing for 2024 but the smh10 is an older product so that didn't affect my opinion too much.

I needed a new helmet clamp kit for the new Ruroc that I purchased. I always use Sena and as always, the quality is great. No complaints

I always hated the stupid boom mic that comes with the SMH-10. I always had to adjust the boom mic every time I put my helmet on. This clamp eliminates the boom mic, and allows you to route the wired mic right to where your mouth would be in the helmet.This comes with a long piece of sticky Velcro that allows you to just place the Velcro vertically inside the chin part of the helmet so that you can place the mic as high or as low as you want without removing and re-sticking little round Velcro pieces. Very convenient, and cleans up the helmets look very nicely compared to the boom mic clamp.

nice not having to remove speakers from previous helmet... allows use of sena on multiple helmets...