npt 1/2 home brew bulkhead ball valve stainless steel 304 for Homebrew beer Kettle tap equipment kit, weldless water tank spigot (1 pc)

Worked great. I didn’t love the rubber washers for installing on an igloo cooler because they’re not thick enough and leaked. I put other larger washers on the the leak stopped. The valve itself is great quality and has performed well for several batches of beer. I think this will last for years.

Excellent kit with all necessary parts for my Gott cooler. Leaked at first but this was solved by using the supplied Teflon tape on inside as well as outside threads. I used the supplied silicone washers on both inside and outside against the cooler surface.

Prior to this purchase I was at first not sure due to some of the reviews. Then after looking at some of the pictures and re-reading the reviews in question that had pictures, all I have to say is those folks cannot follow simple instructions. YES you have to use the Teflon tape and I recommend wrapping at least 4/5 times. In addition the silicone washer goes on the INSIDE, not the outside. Use two adjustable wrenches when building too, don’t worry about over tightening, yet do not put HeMan strength into it. I did not put Teflon tape on the inside, since that’s why there is the silicone washer, also for sanitary reasons to clean. Lastly I am very satisfied with this purchase, for it saved me a ton of cash not having to purchase a pre made wort chiller and separator that goes for up to 250 dollars. Also first time filling with water it DID NOT LEAK.

This was easy to install - I purchased a Harbor Freight step bit to bore the hole 13/16". You MUST use a washer on both sides to properly squish the silicone gaskets provided. I added a small thin nut on the outside threads of the nipple to jam up against the back of the ball valve to keep it oriented correctly. I did not like the restricted flow with the interior gaskets installed so I did not use those (last photo of white gaskets). They install inside each end of the ball valve and drastically reduce flow.

Very well made and strong.If ever I need an other 1 I will order from this company.A solid 5 stars.

I used this to convert a home depot water cooler to a mash tun. I did need to buy a female 1/2 npt adapter for the inside barb fitting. I didn't use the nut as is took up too much space on the nipple, but the female adapter was able to hold the washer in place to seal the o-ring. Tested at 190 degrees, no leaks. Only 1/3 of a quart of dead space at the bottom with the false bottom I used. Definitely recommend.

The price is very good for the quality. I ships with a roll of sealant tape and extra rubber washers.

Took for every to get this because somehow Amazon lost the original shipment.I got it today, put it together and installed it. The install was into a Lowes round 10 gallon igloo cooler. It went pretty easy, using only the teflon tape the valve came with, washer, and nut. I reused the rubber gasket and plastic washer that was in the cooler.Now for the leak test... I poured 3 gallons of water in the cooler to check for leaks.. I didn't see any leaks around the bulkhead or where I jointed the nipple to the valve. But I have a leak.. it's really slow, but it's there...Watching it for a min, I noticed water coming out the valve.. ... sure nuff.... I guess the valve just isn't a water tight fit... I'm going to see if it gets worse, or not.. possibly stop?? Don't know.. but I have to rate it 1 star because it leaks through the valve itself..Anyone know if there's anything I can do to stop a leak like this?