Official Creality Original Replacement 3D Printer Build Surface Heat Bed Platform Sticker Sheet for CR-X CR-10S Pro 3D Printer 320X310MM (Pack of 3)

No issues works perfectly for my cr-10s pro V2

May work for some people but not for me. One used and 2 in trash.

I am somewhat new to the 3D printing world and have a CR 10S Pro 3D printer that was working well initially but could not get adhesion of prints but is entirely corrected with 3 solutions. I tried purchasing a glass surface and it did not work for me. 1. What worked was this product which replaces the original build surface which is an OEM adhesive replacement pad that adheres to the aluminum board and is sold 3 for $21 on Amazon which helped dramatically but not completely. This product should have been included in the original printer, I did not know the bases wore out and how easy it was to change. 2. Bed Weld product was the gamechanger for me, all of my prints held firm however I had a few that had a problem toward the end of a long print. 3. This product prefers a base temp of 60 degrees C and you must turn off the economy switch to keep the base warm at 60 C so it continues to adhere. Never have had another problem with anything printing.

I was having some problems with adhesion and had previously used a 3M bed sticker sheet. The 3M sheet worked ok (sporadically) but I still had one print failure after another (due to adhesion). So I gave these a shot. The first print I did...BAM! it worked like a charm. I have done about 6 prints with these so far and each has come out perfectly. These sheets seem a little thicker than the 3M ones, so I've also kept the bed temp at about 70, which I think helps as well. I'm using a Creality CR 10S Pro. I would totally buy these again.

I was delighted to find this OEM replacement. There are a lot of options out there and I've generally been happy with the CR-10S Pro original bed. Like others have noted, it's not out of the question to bump or drag the nozzle on or over the surface which can leave divots and grooves. As I get better at managing Z-axis control, it is less of an issue but it can still happen. It's nice to have a 3-pack, just in case. The adhesive is quite strong, so alignment prior to allowing it to touch is critical. I got one edge perfectly lined up and then allowed the sheet to stick slowly from that edge (to avoid any air being trapped under it). It took some effort to get the old one off and some xylene to remove the remaining adhesive. Be careful not to bend the aluminum bed while peeling the old sticker off. Once it was one, it was every bit as good as the original that came with the Creality. Highly recommend.

Great build plate sticker.Seems better then the original. Metal plate works better then glass and less issues with this printer.A metal capacitive sensor works better also. Buy theseBed stickers while you can. Great to have a few around.Creality Original.

Did not come shipped in a box or a firm envelope; it came in a plastic bag. When arrived, items came dented as a result.Item description suggests that you can clip this onto the bed if you do not want to use the adhesive side to tack it on.did not work that way for me as heat from the bed makes the platform float up.The cr10s pro has a bad habit of crashing into bed; i bought this to replace the bed i had before. The cons of the stock bed is that it is easy to get scratched up, beat up, and have filament baked on when the tolerances are too tight from nozzle to platform. A kind of good thing is that the bed holds prints very well, however, on that same note removing prints is a pain. heat bed up to 60 degrees to have a fighting chance of removing prints.Ikea mirror gives much much better results in the end but mirror is smaller than heating bed.

Good one I use hair spray on it for good stick of filaments