Irwin Tools IRWIN 10-Inch Miter Saw Blade, Classic Series, Steel Table (11870)

Used this in a miter saw on a baseboard job in a garage. Job was spec'd out for vinyl mouldings due to moisture. Needed a fine toothed blade and was skeptical at first due to low cost. Checked the blade for run out and it passed just fine. Clean cuts, stayed sharp( not hard to do on vinyl) and saved a ton over a carbide blade. Miters were tight. Used one of these blades before on aluminum columns for the front of a house. Ran it backwards for that job and it worked great. It was a consumable item (throw away) on that job after a lot of cutting. It got through the whole job for 11.00. I'll use these again for specific tasks.

This is a fine 10" blade, thin with a large number of small teeth, designed to cut wood, plywood, veneer, etc. precisely, leaving a very smooth cut. It DID all those for me, and did not cost a fortune!

This is a great blade for basic cuts and general woodwork — clean edges and smooth performance on untreated lumber and trim. However, the moment I used it on pressure-treated wood, it started to burn and dull out quickly.It’s a good, affordable blade for light-duty work or softwoods, but if you’re planning to cut anything treated or tougher, you’ll want something more heavy-duty. Still a solid value for standard projects.

The saw blade works great.

works we;;

Great price on a functional blade. It's nice to have at least one high tooth count blade for certain materials, and/or where you want a very clean cut. Not carbide-tipped, so don't expect long life.

i bought two of these blades form Lowes for $24.99 a pop to install my laminate floors. I burned through 2 of them for 400sqft of laminate. It cut really nice, but like everyone else, they dull incredibly quickly and warp. but as far as price, its cheap, and i dont mind spending $12 and ordering 4 more of these to finish the laminate for the rest of my house which is another 1000sqft.

Worked great for cutting my vinyl blinds.

We use it to cut 3-4 mm acrylic boards the cut came out smooth and precise. Recommended.

Je l’ai commandé pour couper du Polycarbonate (c’est un genre de plessiglass avec des alvéoles) de 8mm et je suis très satisfait. Ça coupe très bien et fait une belle coupe propre sans éclat du plastique.

Utilizo está sierra para cortar aluminio y funciona excelente.

المنشار رخيص ومو حق قص كويسيميل مع القص ماعجبني ابد رميته

While I haven't actually done any cutting with this blade, its cobstruction and sharpness are good.