Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.811" Overall Width: .99" Dovetail Width: .500" Mounting Hardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw Red Dot Fitment: Vortex Viper/Venom, Burris FastFire, Crimson Trace CTS-1200, CTS-1300, Docter, ADE RD3-001*, ADE RD3-02*, ADE RD3-009* *All ADE mounts require 6-32 x 3/8" screws.Please note: We have found that some red dots commonly found on such as the UTG and ADE may not hold the same tolerances as the red dots that this mount was initially created to work with. These dots may not fit properly on the posts on the plate. We would recommend either sending the red dot back for an exchange to whichever seller you purchased it from, or open up the holes in the bottom of the red dot to accommodate the pins.Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Minor modification may be neccessary for Rock Islands. Our products should be installed and checked by a qualified and competent gunsmith. Installation Instructions - Remove the rear sight* - Install the EGW Sight Mount in the dovetail - Tighten set screw (if applicable) - Place the red dot sight on the EGW Sight Mount
R**A
Fits RIA 1911 snug; use sight tool!!
Worked for my RIA 1911, but it was a snug fit. I Suggest buying a sight tool on Amazon, as it does take some torque to get off old sight and putting on adapter on a Rock Island. Did scuff up the side i used the sight tool on because of the torque used to push the adapter in. Other than that, ghe adapter worked great for my ADE sight.
A**R
Too large
Had to file down a lot.
Trustpilot
1 month ago
2 weeks ago