VARICART 24V LED Driver 60W Power Supply 2.5A, AC 240 to 24 Volt DC Transformer, Constant Voltage Switching PSU Adaptor for Light Strip MR11 GU5.3 Bulbs

Used for 24v under cabinet lighting, small enough to be tucked out the way, provides plenty of current from a small unit, and doesn't get particularly warm. Covers over wiring and terminals are a bit fiddly.

Easy to work with and recommended.

Works as expected. I wish the connectors were better but they are OK.

Fitted driver to my outside LED lights in waterproof junction box and worked perfectly.

Easy to use

The media could not be loaded.

For those that want to know, yes these are actually safe and good quality!Input is filtered, has fuse protection, common mode choke and even an NTC.Mains separation on the board is fine - good few millimeters of bare pcb, and the Y-cap is branded and correctly rated.Current rating is correct, and no voltage droop as you approach it.I'd have no issues with the output going to an LED strip that could be accidentally touched, and I don't say that lightly. Pffft, light-ly.It's good, buy one!

I bought this LED driver to replace an older one that had stopped working after about 4 years. the LED driver that i had before was a 1.25A, 25W, 24V supply from a 220-240V input however despite this LED driver being 1.25A and 30W, it was unable to supply enough power to run the exact same strip lights that the lower capacity driver was able to handle. when i wired it all up, the LED strips were flashing, after cutting out one of the strips of LED lights, they lit up without issue.this might be something for any potential buyers to consider, you may have to opt for a higher capacity LED driver than this.

Bought 5 of this and all works well and is of good quality.I recommend this product

Conforme à mes attentes, et rapidement livré.

Perfetto per riciclare i led di Ikea avanzati, ovviamente ho prima confrontato le caratteristiche di questo driver con l’alimentatore originale dei led, perché se non è adatto si rischia di non farli funzionare, di romperli o farsi male… con la corrente non si scherza, bisogna sempre essere sicuri di ciò che si fa! Lo consiglio.

LED Trafo 220 auf 24VRezension aus Deutschland vom 18. November 2022Wattage: 15.0 WattLeider habe ich mich beim privatkauf gebrauchter IKEA Vitrinen übers Ohr hauen lassen, Beleuchtete Vitrinen wurde angeboten, sogar schön in Plastikfolie verpackt , damit nix kaputt geht. Oder damit man nicht nachsehen kann, ob alles komplett dabei ist. Genau so war es dann auch. Vitrinen: 4 Stück da. Beleuchtungen : 4 Stück eingebaut. Netzteil? Verteiler? Fehlanzeige. Und diese Dinger brauchen 24 V.Zum Glück habe ich nach einiger Suche diesen Transformator mit den passenden Anschlusswerten gefunden. Ist nicht so einfach da aus den meisten dieser Dinger nur 12 V rauskommen.Ist billig, sieht billig aus, die Kabeln müssen direkt auf die Platine angeschraubt werden, welche etwas fragil aussieht. Ich habe mir deshalb einen kleinen Holzkeil zurechtgeschnitzt, den ich beim Festschrauben der Kabeln untergelegt habe, damit die Platine nicht bricht. Funktionieren tut das Teil, die Wärmeentwicklung ist minimal, Leistungsausbeute OK. Somit habe ich beim Kauf keinen Fehler gemacht.

Ok