40' Feet Speed Wire 9 Conductor 18 Gauge Audiopipe Car Audio Speaker Remote Wire

I also purchased the Crutchfield cable that's nearly identical. This one is much better quality with thicker shielding and better colors on the wires inside. Very nice!

After running this wire to a 4 channel amp -the strands were soo small the amplifier screw couldn’t even grab the wire .Once I did finally get it to connect to the amp the sound sounded as if I had a bad rca . Made the amp clip at mid volume.So I yank the (speed) wire & ran some 16 ga NAPA real speaker wire & when I turned the music on it was loud & clear .This crud wire will make you do the job twice.NOT WORTH YOUR TIMEWhy even produce wire like this? Obviouslyno quality control , just a scheme to sell something that’ll never work correctly.

We do a LOT of customization at our motorcycle shop and use this 9 wire line all the time. Flexible but strong and does the trick. Going to purchase another spool this weekend because I'm about to build some custom controls for my Jeep Gladiator and will use this ( again ) on that project.

I really apreciated the ease if installation this gave me. I ran one run of this down both sides of my car to run a signal from my head unit to my amp then from my amp back into my factory speaker wiring.

Not a bad roll of speedwire, served the purpose, but would like to see a version with wires a little thicker maybe 16Guage

Used this to wire all the speakers to be powered by an amp in the trunk due to an under powered head unit. Ran one length from head unit to amp then another back to behind the head unit to speaker wires from the amp. Worked perfect. 9 wires was perfect because it was enough for all speakers, plus a ground and a ignition trigger wire. Yes these are like cables when youre running them in the floor trim but once you get them ran, you don't have to worry about individual speaker wires. They are well insulated with foil and the rubber outer. Much recommended. Good deal

I've used this speed cable for 4 installs of after market head units and amps. I connect the speed cable directly to the factory stereo wiring behind the head unit instead of using the head unit wiring harness (bypassed) by running this directly from the vehicle factory wires to the amp I can use the factory door connectors provided and it makes the install so much cleaner..... perfect for a 4 channel amp

I am running my amplifier signal to my door and dash speakers (2000 chrysler town and country) at 2 ohms.