Pro'sKit 300-151 Strain Relief Crimper, multi, one size

I purchased this Crimper based on the mostly positive reviews. It's a nice solid Crimper. It's constructed of 3mm or ( .118 Inch) thick Stamped Steel Stock which seems to be more than adequate. The grips are comfortable and the spring work well. The pivot was not sloppy at all. This crimper was designed to do the smaller diameter strain relief bushings. The crimper jaws have an approximate 7mm Radius or 14mm Diameter to them. I have both small and large strain relief bushings and this crimper will not work on the larger ones without leaving small divots in the bushing. This is not a fault of the crimper, it's just not possible to do both large and small bushings well with only one jaw radius size. It's kinda like snap ring pliers one size pliers does not do all well. It would be nice to have a several piece set of these crimpers with several different jaw radius sizes to cover all bushing sizes. Also the jaws on my crimper did not perfectly line up when the crimper is closed. There was a very slight offset. My crimper is probably within the manufacturers production tolerances, so its not bad. It is stamped "TAIWAN". What I really like about this crimper is it's physical size, which I think is just perfect, it's not too big and it would be great at getting into tight areas.

Easy-to-use electrical cord strain relief bushing installation tool worked perfectly on my first attempt. Simply squeeze the bushing around the cord with the tool and insert it in the pass-through port. Done and done. Made from high quality materials. Reliable. Comfortable grip. Recommended.

When you need to remove one of those fittings without damaging it, this is the tool. It is perfect in it's function and will sit in my toolbox forever as I need it.

Worked as intended

I was needing to replace a cord for my air compressor. The grounding plug was broken off. So I removed old cord and it had a stress relief bushing. Of course the ones on Amazon were either too small or too expensive and difficult to size. I took cord to a tool repair store and purchased new bushing for $6. I tried to push bushing thru hole with needle nose pliers or channel locks without success. I just conceded that I needed a new tool! So I bought this on Amazon. It took 5 min! This is what you need! Don’t stress. Get this crimper.

The tool was too small to get enough leverage to install the wire clip

I didn't want to spend a lot of money for these and this one is priced right. Don't let the cost fool you. This is performing admirably. I have had no issues while installing/removing numerous cable strain reliefs in the last year. A solid purchase for me.

Hereunto I had struggled to clamp down on those Heyco strain relief parts. I broke 50% of the strain reliefs using plyers, and struggled to install the strain reliefs. No more struggles. The Pro's Kit 300-151 strain relief crimper made installations a breeze. Struggles have turned into easy installations without breakages. Highly recommended!

These are a must have for the press fit strain relief on appliances. Saves from ruining them and damaging the replacement wire.

Buenas pinzas

Value for the ease of dealing with annoying strain-reliefs! Having destroyed many strain-reliefs with regular pliers, these are great to have in one's toolbox.

Seem cheap, but they do work as good as the heyco ones.

if i put a strain releif in these it squeezese it together so i can stuf it in awhole