HOW TO OPERATE 1.To fit the 1.5 die mold, undo the screw on the left side of the base. 2.Push the steel bar completely in, and tighten the screw. 3.Insert the 1.5 upper punch into the hole in the left die mold cavity. 4.Fix the 1.5 middle die mold on top. 5.Pour in the powder. 6.Insert the lower punch into the hole in the die mold. 7.Tap sharply several times with a hammer. 8.Lift the middle die mold out with the lower punch, still attached. 9.Insert into the die mold cavity on the right. 10.Tap gently with a hammer to release the tablet 11.Slide the finished tablet out. HOW TO CHANGE THE MOLD 1.To change the mold to 5KN or 6KN undo the screw on the left of the base. 2.Pull the steel bar out until the line on top of the bar is lined up with edge of the base. 3.Tighten the screw. Repeat the procedure.
Trustpilot
1 week ago
2 months ago
