Magazine Speed Loader for Smith & Wesson M&P 9 Shield (1.0, 2.0) 40 Shield, Springfield Armory XD-S XD-E 9mm Single-Stack Magazines, Hilljak Quickie Loader QL9S - Hunter Green

I have MagGuts +2 springs and followers (and a few Taran 10 round magazines for the Shield. This gets them filled up easily. I recommend loading the first one without the unit and then you can set the mag base on a table and thumb-push the loader, or, put your thumb under the baseplate and hold the unit between fingers like a syringe and load without a table. 3-D printed, but that gives it just the right texture for grip. Good job!

Works great

Using this to load M&P 40 2.0 Shield mags. It works but it's pretty clunky and takes a lot of effort and coordination due to the tolerances being way too tight. Not for fast loading for sure. So it's just.....meh.

Fast service, Great item. Exactly as ordered

The flange to grab is solid, but it could maybe be a bit more flared or grippy. This is for the single stack, which is clearly stated in the listing, and I have a double stack so I wasn't able to use it. Feels and looks sturdy and like it will last well though

does not fit M&P 9 Shield magazines — not at 10 or 13 capacities. I had trouble getting it over the top of the magazine and then couldn’t get it to go low enough to depress the ammo so I could load the next round.If I am a moron, I’ll happily change this. I did my best to follow the directions.

I was having difficulty getting the last few rounds loaded into my magazines. This works very well. Takes just a little wiggle to get each round in, and I can get the full 8 rounds loaded quickly.

Fits my mag perfectly. Easy to use with a bew mag with a stiff spring.