LEDMO Dimmable LED Driver 12V DC 60W Quiet Operation Universal Regulated 12V Transformer Input/Output Isolation Protection LED Power Supply for Strip Light

Been using these for a few years , no flickering , quiet and dim great

I purchased this driver because I was installing a lot of LED strip lights. I needed a driver that could handle the load of all the LED’s.

Like others have mentioned it will be a pain to try to open the Orange end caps….Its plainly just a bad design. Why the 4 stars. Please find a screw driver that will fit through the bottom slots and gently push forward. The end caps will easily dislodge itself. To close, gently push it back and it’ll snap right back in. “Gently” because these are only secured by plastic channels that could easily break off and you won’t be able to close it properly after.Hope that helps.

I had an old 30W driver running some LED lamps but I wanted to add more lighting but it would exceed the capacity. I have the driver connected to an Eaton dimming smart switch. After reading the reviews I decided to buy this driver.When it arrived It was well packaged and came with a small "instruction manual". I wouldn't necessarily would call it an instruction manual because its mostly warnings and what the driver features are. If you need instructions on how to correctly wire this please for yours and everyone else safety, hire a professional. Pretty straight forward High voltage on one side, low voltage on the other (observe correct polarity). The only issue I had which seems consistent in the reviews is removing the covers to access the terminals and mounting holes. I installed mine indoors so I cannot comment on its weather resistance but looking at the design it would need protection if you mounted it outside. When the driver is powered there is a green LED that illuminates. I have 5 - 12V 7W LED MR16 lamps connected to the driver (35W total). The dimming is very smooth and effective through the entire range with no flickering or stepping. The dimmer I'm using is an Eaton RF9540-NAW ASPIRE Single-Pole Multi-Location Master Dimmer Light Switch.

I added more leds and it exceeded my power supply’s rating. The lights would flash and then go out. This solved the problem. It’s about 100 feet of led strip lighting on boom and record shelves.

As many have said, the hardest part is getting the orange cover off to wire. As someone had said you can easily pry it off by wedging a standard screw driver under cover an prying off. cover come off straight up through vertical channels. It's is sturdy and will not break in doing so. powering under cabinet strip lights in kitchen. transformer is in attic however there is NO hum what so ever on dimming down to practically 1 % with the Z-wave dimmer I am using for computer control. Wish i would of seen earlier.. took me over a year of looking aroung..

Updated: Go figure less than a month after writing a review, I’d have to come back and change it. I had a customer try this on a setup that’s full compatible and both drivers they ordered had issues. Sad to say I’ll have to switch brands after spending hours dealing with that.Original: I’ve bought 4 of these now, one being over 4 years in constant use. They dim well, minimal noise and hold up to the test of time. So far, these are my favorite dimmable drivers.

Had a couple of these. Can't handle half its rated power and no way can it operate in environments of up to 70 deg C.