Goliton AUX 3.5mm Cable Replacment Connect MP3 Phone Audio Compatible with Mazda 2006+ Car Player (2 Meter / 80 Inch Long)

I'll list the good, the bad, and some installation tips. The price of the product is unbeatable, especially since as we've seen with the iphone 5, your iphone integration unit can quickley become obsolete. Just a simple line-in. Works for everything. The sound quality is pretty good. I think a cd sounds better but that's to be expected. But there is no audio feedback from the engine, even when using a basic audio cable extension. The only negative I had was that the cable is a tad short - but that really depends on where you want it coming out. I ran mine through the center armrest box. The cable stretched the whole way, but only had about 4 inches of slack once it entered the bottom of the armrest. If you run yours through your glove compartment or just out the side of the center console (near your legs) you'll be fine. I didn't notice a sound quality difference when I added an extension to mine coming through the armrest. As for installation tips, these will only apply to the 2008 Mazda 6, though I'm sure other Mazda6s of that generation will be similar. Here's a list of tips. 1) Use the GTA car kits video on youtube as a guide. 2) When taking off the 4 front-facing screws that hold in the radio, make sure you get the correct bottom 2 screws. Because I'm tall, I didn't see the actual 2 lower screws and instead unscrewed 2 screws that were holding in the large plastic piece that makes up the armrest. After yanking on the radio for a while and questioning my strength and manhood, I found the correct screws. 3) That being said, if you partially remove that large plastic piece (same piece that makes up the armrest) it actually makes threading the cable much easier. You'll need to remove 5 additional screws (besides the 2 I mistakenly removed). 1 one each side near the driver's and passenger's legs. 1 in the middle near the hand brake, and 2 inside the armrest. Also, disconnect the armrest power outlet. You don't need to take it all the way out, just loose enough at the front so you can thead the audio cable down from the back of the radio. 4) At the bottom of the armrest box you'll need to make the hole bigger to help the cable fit through. The holes are actually a little plastic drain. Just punch out a little bit of the plastic with a lockblade and thread the cable through. 5) To make sure my short cable won't ever fall back down inside, I zip-tied the 4 inches of slack that I had to the little plastic drain at the bottom of the armrest box. It's solid. It sounds complicated but it isn't, trust me. If you are even a little mechanically inclined (like, you set up a Big Lot's bookshelf once) you'll be totally fine. It sounds like there's some improvisation and ghetto-rigging involved, but it's very straightforward. It doesn't take long and it's well worth the effort and money savings. The hardest part is threading the cable down from the radio. Just get a flashlight, stand on your head if you have to, and look for a clear path.

As others have noted, there is a YT video that shows how to install this in a Mazda MX5 (Miata). If you Google for "gta Miata" you'll find it -- it's entitled "GTA Car Kits - Mazda MX-5 Miata 2006-2008 iPod, iPhone, iPad, mp3 and AUX adapter installation". However, I found some differences/ problem when installing on my car (2008 GT, with the Bose audio system factory-installed). 1. The video states that you must remove a plastic part from under the steering wheel, then remove a metal plate, then remove a 10mm bolt to release the unit. That bolt wasn't on my car, so none of that was necessary. 2. So all I had to do was remove the plastic side panels then remove 2 Phillips screws (as shown on the video). 3. Then I could pull the whole unit out. BUT when I did that, the antenna cable - which (unknown to me) was tightly tied down behind the unit, with almost no "free" cable -- got disconnected from the back of the radio, so I lost the radio signal. And there was no way I could have re-inserted the cable into the back of the radio -- the cable was tied down, no way to pull it forward to put it into the radio before sliding the unit back in. LUCKILY I had a spare male to female 3.5mm extender cable, so I was able to use that.....snapped the female end onto the antenna cable, and then I had a lot of free cable to play with, so I could put the male part of the extender into the radio. Then I tucked the rest of the extender, as neatly as I could, way back under the dash, and slid the unit back in. Works perfectly. But my advice is - if you have a factory-installed unit, consider having an extender cable on hand before you begin !!! OK, that said: the aux cable works perfectly. I snapped it into the back of the radio, and ran the excess cable under the unit as I slid it back in. Turned out that there was a little space under the front edge of the unit after it was back in place, so there was no need to cut anything in order to make room for the cable. Plugged the jack into my phone's headset socket, and when I pressed the Aux button on the Bose audio unit, I get great-quality audio through my car audio system. Terrific. One small downside (not the fault of the cable, I don't think) - as others have noted, if you simultaneously charge the phone via a USB cable from the "cigar outlet", it works but you get a nasty interference noise coming from the speakers. Not a problem for general audio (which doesn't burn up the battery too much) but it'll be a problem if you want to use navigation with voice directions, because that requires GPS, and that will eat the battery. EDIT: I bought a ground loop isolator from Amazon, for about $10, and that took care of the noise - now I have crystal-clear audio, even when charging via the USB....

Bought this a few weeks ago. Wired into my stereo and fished through the car to have it come out of the center console. Worked great. First issue was a slight buzz or static sound when the charger's connected at the same time as the aux. Second was that the aux cord that connects to the stereo is actually a little flimsy. After a few weeks the music would play out of one speaker or another or not at all or perfectly depending on how the aux is connected to the phone. Can only blame myself for maybe being too careless with the cord. Looked online over the buzzing and you can buy something called a ground loop to rid yourself of the buzzing while charging. You plug the ground loop like you would your phone and have another aux cord run from the loop to the phone. Think of it as an extension between two aux cords. Aux is included with ground loop btw so good deal. Ordered that as well as another aux to stereo cord since mine had broken and figured that I can leave the ground loop and aux to stereo cord in my console and run another aux which I'll consider a disposable one from the console to my phone. That was if I mess up the aux again I can just get another aux and connect it back to the ground loop and avoid having to take apart my stereo again. It's a good product. You just have to do your best to make it last for you. 10/10 would recommend.

Le câble est livré dans un sachet. Il s'adapte parfaitement sur le connecteur libre de l'autoradio d'origine de ma Mazda 5 de 2007. Le démontage de l'autoradio se fait a l'aide d'un tournevis cruciforme et ne prends que 5 min. Tuto disponible sur Youtube. Le son du téléphone devient alors accessible sur l'entrée Média (Aux) aussi bien en musique (Spotify) que téléphone (son de l'appel dans les hauts parleurs). Mon tél est un Oppo Reno 2 (Android)

Funciona bien. Mi coche es un mazda 3 sportsedan del 2007 y no he tenido ningún problema. Además en Youtube hay vídeos donde explican como instalarlo tu mismo. El problema es que es un poco trabajoso porque hay que desmontar algunas cosas del salpicadero del coche pero eso no es culpa del cable. Además la longitud del cable está muy bien permitiéndote colocar el móvil en el asiento del conductor tranquilamente.

Mega fast delivery. Fitted to my NC MX5 in twenty mins as suggested by other purchasers without removing the header unit. You do need nimble fingers and be quite flexible to get your head up behind the glovebox to see. I recommend you tape this harness to an existing loom just in case it gets accidentally pulled as the wires leading into the plug are quite fine. Works perfectly well , good audio quality. Cheap and very effective modification. Very pleased :-) cable length is very good too. I recommend you remove the aerial lead to fit the plug then re fit. Best 10 quid I've spent for a while!

アクセラ BK5Pにて装着しました。MEDIAボタンを押しAUXの表記もされ、音質も問題なく、、AUXのみの為、配線のわずらわしさもなくスマートです。敗戦は中央のドリンクホルダーの四角の場所から出しました。灰皿から出すか悩みましたがこちらにしました。 他社製品、純正品より安いのでオススメです！

Did exactly what was advertised. My Mazda3 now has aux functionality. Great adition.