EEEKit 13 Pack Rotary Spot Weld Cutter Remover Sets Double Sided, 3/8'' HSS Drill Bits Hex Sheet Metal Hole Cutter Remover for Power Drill Spot Welding

Do what you need them to do at a decent price. Cutters are sharp and seem to be hard wearing. Used more expensive engineering products and been far less satisfied.

Having used many of these over the years, I can say that these are the best I have purchased. Quick to cut and last for ages.

I tried to order two previously, only showed one in stock, so this is my second purchase of this item

Does the job as expected

Good

I’m so disappointed to order from the seller

Depth of the blades is really inconsistent and poor. The preinstalled blade (one in middle) was great as the blades were deep and therefore it would cut really well. But if you compare it to the other ones, you’ll see the other blades are far more shallow, and therefore cut dreadfully or not at all.

Soon went blunt 6 spots they lasted then useless

I've used the stepped drill bit style over the years, they work fine. But I prefer this style now much better. Simple center punch and a clean cut only on one side of the double panel. Leaves a nice clean weldable surface. Sure it's not super high quality, but it works perfectly, cut off two full body panels on a Jeep CJ, probably over 50 spot welds cut out and this tool made the job easy.

Muy práctico, me ha servido de mucho para quitar muchos puntos de soldadura del coche, tres cuestiones a tener en cuenta primero marcar el centro del punto soldadura con una broca pequeña, así se evitará que la púa patine, segundo lubricar con aceite y limpiar con una brocha para que no se queden las virutas pegadas en su uso entre punto y punto y lo más importante una velocidad muy baja, un taladro a batería al mínimo revoluciones. A mi así me han funcionado perfectamente.

These are great, i used one to cut a panel. 16+ holes drilled and the bit can still do more. You can tell it is a much better quality cutter and bit holder. I am comparing it to the harbor freight version which is absolute garbage, i went through 3 of them then i decided to buy this one. I recommend it!

For the cost these things are worth the money, I gave it 4 stars because I did have one break on me (out of 5 that I have used) but they last a really long time and the cutting actions stays with it.. they aren’t perfect but I have gotten less out of a single bit for the same price as a 12 pack of these.

I was not expecting much. I generally us Blair brand but there getting expensive . So gave these a try. Blair brand I get 1-5 holes per side there very brittle. This set 1st cutter did 58 spot welds they do not cut as fast as the Blair brand (I think there 1 tooth finner). I have started the second cutter 22 holes so far. I do a lot of body repair on classic cars and these work great. I use a low speed 1/2" air drill . center punch the spot weld slowly start drilling and once it start cutting apply median pressure.