Wicked Ridge String Dampening System - Reduces String Noise & Oscillation - Compatible with Invader 400 & X4, Rampage 360, Blackhawk 360, Warrior Ultra-Lite, Ranger X2 & Raider 400 De-Cock

Easy to install, crossbow is much quieter.....highly recommend

Great quality product. Fit and worked as advertised. A bit cumbersome to install with tools that were provided.

The screw holes are not threaded. It was a pain to put the first two in with the included screw driver. So, I did what any smart man would do. I lined up the screws with holes and sent it with a drill. Less than 1min I had the remaining screws in. Took almost 15min to do two screws with the provided screw driver. 4 stars because the holes weren't threaded.

Installed on my new wicked ridge by tenpoint crossbow after using the bow to do target practice and noticed the bowstring and limbs on the bow were loud so I decided to order these dampers and also the limb silencers as well and that made the crossbow considerably more quiet actually it is scary quiet now can not wait to use it during bow season here in western NY this fall. They were incredibly easy to install and came with very good directions fit directly on the bow and required no adjustments. Wish Tenpoint had included these on the bow straight from the factory but well worth the price. I would highly recommend these to anyone that has purchased the Wicked ridge crossbow.

These fit my WickedRidge Rampage 360 and do reduce the noise level quite well, though I did have to shorten the stops by about an 1/8". The torx screws that come with this are self tapping and very small so that makes them very hard to install using the little wrench that comes with it. Do yourself a favor and throw that little wrench away and get a full size screwdriver with the proper torx bit to tighten it down. IMO all crossbows should come with these as well as some sort of limb saver preinstalled.

So I am very thankful I bought these. Man do they reduce the noise. I just wish I bought a crossbow that already had them one. When putting in the screws you are tapping the bottom connecting plate. The directions do you tell you that you need to use some force to lock these down. We ended up using a pair of vice grips holding the star wrench to crank them in. But they are definitely well worth the money. And make a significant difference when shooting the crossbow. I have mine installed on the wicked ridge invader x4.

Honestly I couldn't tell any difference in shooting or accuracy. However I killed a doe and two nice bucks this year and the bolt hit where I was aiming. Last year I shot a doe and buck without the dampeners and they both reacted to the shot. The Bow should have come with it from the factory

screw heads can strip out easily using provided tools but the product is a valued addition to my crossbow

pas essayé encore mais l assemblage c est fait facilement.

Perfect fit

The riser mount pieces are difficult to screw into with the provided self taping screws so I recommend pre-screwing them into the bottom half of the mounting pieces first. You also may have to trim the rods that go from the riser mounts to the rubber stoppers. I had to shave off about 1/8” of material to achieve the recommended contact required by TenPoint, Several other reviews have expressed the same issue. Not exactly plug an play condition.