Cap Barbell Unisex Fm-safe13rd CAP Barbell Safety Catches Spotter Arms Red, Red, Safety Catches Spotter Arms UK

I've seen these before I wasn't sure about them because the pin seems quite thin however I put them on the rack and they work fine, the only thing I would say is they are prone to moving so I have glued a bit of cardboard where they fasten to the racket self but yes amazing value

Does the job well

They fit on any 2 inch square tube. Very well made and sturdy. You will bench press alone safely with these. I tested with 225lb but it would definitely withstand much more. Price is also cheap. I highly recommend if you have a 2 inch tubing bench or power rack. I drilled some 1/2 holes on mine, at desired heights and it saved me from buying a higher end power rack.

For the price these are great. I have a CAP rack too so they fit well and are long enough to catch squats and bench press fails. I have concrete weights so i like to put the arms on the bottom hole to deadlift so the plates don't hit the ground. I can only deadlift 315 but they've held that weight well even at the very end of the arm so they should keep you pretty safe unless you're a beast. Not really scratch resistant but i don't really mind. Does the job for me but they are designed for a rack that only holds 500lbs so i wouldn't expect to be able to push them much further than 400

Does not work with my Mikolo 2"x2" frame with 1.1" diameter holes. I thought this was a pretty standard rack, but the rods are more like 1/2" and are very loose. I am returning them. Maybe this is my fault for not doing research on the size of the rods and holes. Unsure what rating to give because it's partially my mistake but wanted others to know.

They do fit well and appear to be a good design for strength. However, the box arrived damaged and retaped by someone, because the heavy steel parts were loose in the box with only a little bit of paper around them. The paper had come off of the parts and the parts were rolling around inside the box during shipping. A lot of red paint came off the parts and was smeared all over the cardboard box. Not a very good paint job. There was a sharp burr in a well that needs to be ground off for safety so nobody gets hurt with it, and the parts were all scratched and scraped up and down to the bare Metal so I will have to repaint them.

Works as advertised though the paint doesn't hold up that well.