EBC Brakes USA Made Double-H Series Sintered Brake Pads FA261HH to Fit VICTORY,HONDA

The usual with EBC: fits perfectly and a lot better than stock pads!

Easy installation, works as they should. Highly recommend for 3 wheel converted Goldwings

2012 Honda goldwing. I knew I had to buy 2 sets Of pads for the front wheel of my wing, I bought 1 pair of these and 1 pair with the identical number plus 2HH , , thinking that was the other side. . It turns out you need to buy 2 pairs of these pads because they are reversible! The shims need to be at the back Of the brake caliper towards the wheel, These pads have them on both sides! They will work for the left side and the right side Of your wheel

Best brake pads out there. Good price for my 3 sets on my Gold Wing. Don’t get stingy on brake pads. Nothing like new pads to make you feel confident.

I planned to replace all three sets of pads on my 2009 Victory Vision (front has two). I did the rear brakes first. I wasn't able to get these to seat in the rear brakes so I sent them all back. Rear pads were good anyway. I went to the dealership to get pads for the front and guess which ones they handed me? These exact ones. I asked them to verify for certain that they were the right ones and they said yes. So, I left the dealership and re-ordered two sets from Amazon as they were $10 cheaper than the dealer. I had the front wheel off putting new tires on so the entire brake assembly was hanging loose. I was able to get these in no problem. Not sure why the rear brakes wouldn't seat because I didn't have a good angle to see what was going on. Probably my fault. As I said, my rear pads didn't need replaced anyway so I haven't tried again. I just put these on and haven't had a chance to really try them out but so far no problems. All I can say is the dealership sells these because they're just as good or better than the OEM pads and those cost twice as much. Also, none of my OEM pads had backing plates on the pad where the pistons hit. That seems silly to me. These have backing plates on both pads. I feel a lot better about that. All my brakes had little round grooves from where the pistons started biting into the pad. Not much, but still it makes me wonder if you could break a pad (no pun intended) with the piston without the plate to spread the load out?

As always EBC pads are fantastic.

Received exactly what I ordered and it arrived in a timely fashion.

Installed on a 2002 VFR800, front and rear. These pads have one slot versus the Honda pads' three slots, but this makes no meaningful difference to fit or function. The pads installed easily with OEM-like fit. They are powerful and bite aggressively, pulling the bike to a halt with less brake effort than the OEM pads. Pads have been great, but cannot recommend them until pad longevity and rotor wear are known.

Would not use other make for bike

Fits perfectly on the rear of my 2001 vfr. They are definetly better than the old worn out brake pads that were on it. I can’t comment yet how long they last as I’ve only been out on one ride since.

The only brake pads I’ll ever use on my CBR1100xx

I have used these in the past, and now again with no issues. The price in comparable all over but as far as the brakes, no issue with this brand or fitment ever.

They didn’t fit my bike even though I checked haven’t sent back as obvious I opened them. Waste of £80