Norske Tools NCSBI558 10 inch 72T Ferrous Metal Cutting Saw Blade Industrial Quality Made of Japanese Steel 5/8" Bore

Writing this review for those wondering if it will work in a regular miter saw that I usually use for wood. I needed to cut a downrod for a fan from 48" to 46". This effortlessly made a straight cut with no burs in a few seconds. Like it was butter. I don't cut metal often, so I don't know how it will hold up, but for what I needed it's 5 stars.

Cut three pieces of unistrut and the blade stopped cutting just as the fourth cut was started. The metal got red hot and stopped cutting completely. Very poor quality.

This thing cuts through steel like butter with almost no sparks, quiet and accurate. A perfect cut. It works perfectly for about 20 cuts then it gets dull and it gets EXTREMELY Loud, you have to really push to get it to cut. I got my moneys worth, it was so much better than using a cutoff wheel. It would be nice if it would have lasted longer but what can you expect for $50 eh? It was worth it. I got 20 perfect cuts that I couldn't have achieved with any other blade

Shortly after buying. I was cutting some 1/8in carbon steel. Got about 8 cuts in. Blade snagged on the metal and lost 4 teeth... Bit disappointing.

The media could not be loaded.  Cuts 1-5/8” unistrut pretty good on this 5000 rpm skilsaw liter saw. So far I’ve only made 80 cuts or so and it’s still good. No telling how long it will last but initial quality is better than expected.

I used it to cut 1" square hollow steel, it made one absolutely perfect cut! after that, it struggle to cutthe next piece and would just heat up the steel and not cut....very disappointing.

Used Ryobi 10” mitre saw rated at 4800 rpm. Made 2 beautiful cuts on 14 gauge 2” angle iron then on the third cut it stoped cutting and began grinding and heating up.

I was concerned with previous reviews that the blade would dull quickly. I made several cuts on 1 1/4” square steel tubes (10 gauge) as well as 1/8” steel bar stock and even some aluminum. All cuts were clean and easy.

I used this blade to cut metal soffit material. Very thin metal however the blade did not last. It cut well at the beginning, but lost most of its teeth after just one job. I expected more from the brand.