MUTUACTOR2PCS Super Powerful Neodymium Cup Magnet with 1/4''-20 Male Threaded Stud, 92lb Vertical Pull-Force Non-Shattering Magnet Base with Nut and Washer for Lighting, Camera and Other Brackets.

Great and strong!

Used to mount a paper towel rack so that it can attach vertically to the side of a steel shelf. Works well with no sliding.

Very stong, hard to pull off steel item once attached. Need to slide to the edge to lift off. Perfect for holding up tools on my grill.

These are beyond my expectations. Wow they are powerful.I was happy they include bolts, lock washers and flat washers. Everything I needed to mount my new work light.

Fit, form, and function of this product is perfect! I will purchase again in the future, as needed.

The product does what it says... it is difficult to move once attached. It peel the paint off my iron fencing. Currently taken off the fencing and used to hold my smaller screwdrivers. It’s overkill but it keeps up with them.

Thank you

I designed a magnetic pickup tool with one of these magnets inside. I used PVC pipe with PVC caps on both ends. The end with the magnet in it has been sanded much thinner than how it came. I made a little bracket and bolted the magnet to the bracket, then tied a string to the bracket so I could pull the magnet straight up and down with the string. I cut 6 inches off the PVC pipe and added a 45 degree angle at the top then put the 6 inch section back on that and a PVC cap on that end. I drilled a hole large enough for the string to pass thru below the 45 degree elboe. Now with a loop in the string I can reach out and pick stuff up and then pull the string to make it fall off of the end of the tube. Sure beats bending over to pick up nails and stuff off the ground. You're welcome.