🔧 Craft Your Masterpiece with Precision!
The uxcell Round Steel Metal Rods are high-speed steel (HSS) lathe bar stock tools, measuring 7.5mm in diameter and 200mm in length. Designed for versatility, these rods are ideal for a variety of machining applications, including milling cutters and custom parts. With a hardness rating of HRC61-63, they offer exceptional durability and wear resistance. Ensure longevity by storing them properly to prevent rust.
S**Y
Heavy Duty Piece of Metal!
Maybe I'm crazy, but I bought this as a poor man's muzzle flash alignment rod for a 10/22 rifle. (The "official" aligners can run like 60 or 70 bucks...) It did the job great for my purposes, fitting down the barrel really nicely. It was easy enough to slide in, but yet snug enough that it didn't wobble at all. One caveat is yes, these can have a millimeter or so of warp distributed over the length of the rod, meaning I could only push it in about 80 percent of the way before it started to make light contact with my rifling. But that was deeper than I needed it to go anyway. Inserting the rod about halfway and then rolling it gently through my fingers gives me a VERY GOOD idea of where my bore/muzzleflash alignment is sitting. If any of this sounds reasonable to you, it might be worth saving yourself 60 bucks to give this a try.
J**Y
I mean it's a metal bar
The dimensional accuracy and straightness seem fine, but if you use it to line up your shhhhhh it's probably too short
T**R
great for jump ring mandrel
works great as a jump ring mandrel. good value. nice surface.
T**S
Hardened steel. But that's a good thing.
Don't expect to cut this easy.
R**E
Item description/photo says 7.5mm/0.3"
Ordered this with intent to make a 7.5mm pin, item mics .287-.290" with calipers which is under 7.5mm. should be .294-.296 but picture also says .3". It's a nice piece of metal so I plan to keep for future but isn't to spec and won't work for the reason I ordered.
A**R
Just what I needed for making shelf pins
I have an old cabinet that was missing some shelf pins. Weirdo size pins - the cabinet was maybe made in Asia because the holes measured 5.5 mm. Nothing American made uses pins that size that I know of, so I was able to make my own pins by cutting this rod into appropriate lengths for the pins.
S**E
worked great, well made
Got this for a wind mill project. The bearing I also got fit perfectly on it. Will be back for more.
G**A
simply put it is a metal rod
not much to say about the item other than i needed a metal rod with these dimensions.
A**R
Tight tolerances!
Worked great for me. Used to replace a bent shaft on a model airplane motor.
Trustpilot
1 week ago
1 day ago
