SIEMID New Generation LED Fog Light Assembly – Retrofit & Upgrade for Hond.a Civic, CR-V, CR-Z, HR-V, Jazz, Odyssey, Pilot, Acura ILX, RDX, TL, TSX 2012 2013 2014 2015 2017 2018 2019 2020 2021

Perfect fit for my 2018 Honda Ridgeline. Zero modification needed. Plug and play installation.Protips for installation: Remove the 3x 10mm bolts and 1 push-pin under the front bumper directly below the fog light. This will allow you to pull down the undercarriage panel and access the fog light. You WILL need a rachet thumb wheel if you go this installation route. I used this: "Powerbuilt 1/4-Inch Drive 2 in 1 Thumb Ratchet & Bits Driver, Finger Ratchet,Red,941248". Unplug the power connector and remove the 3 screws in the back of the fog light and voila. Replace with the Siemid fog for a perfect fit. Put the 3 screws in. Before you put the panel back in, compare the height of the new fog light while you still have the OEM fog on the other side to make sure they are of the same height. I didn't have to adjust anything, the new fog lights came already adjusted perfect.Both fogs are ambidextrous, not L and R as the Honda units. Plastic seems to be of decent quality. Black projector housing makes the truck looks a bit more modern. The performance of the fogs themselves are excellent. They are brighter than OEM fog lights + LED bulbs. The projectors completely eliminate the glare issue with the OEM fog, which was meant for halogen bulbs. The light color is around 5500-6000K, a little bluer than the OEM 4500 Kelvins. Zero flickering. The fogs won't affect the distance of the lighted part of the road, but it increase the width considerably.A replacement fog from Honda is $60 each. Adding in quality LED bulbs, at least another $50-150. For the price, nothing can beat the value of these Siemid fogs. I love these fogs and I would highly recommend them.

These fuglights are amazing.My car shines really bright in front of me and I can see the floor clearly.I recommend it for anybody that's looking for a good fuglights for a acura tl and other models. Good Durability and color it look nice

Great replacement and upgrade. Easy install and happy they are nice and bright.

I’m updating my original review, since I was able to install them after all. I ordered a different set that would supposedly fit and it was defective, so I decided to play around with these and figure out how I could make them fit. I noticed that the reason was that the plastic tabs on the sides of the assembly we’re getting in the way so I clipped them off. It was pretty easy since they are soft plastic;next thing I noticed was that the OEM fog lights have a slit in one of the holes that goes into a T shaped knob. (Idk why Honda does that.) But It was easily solved by using a power drill to make a slit so it would fit. I plugged everything and turned it on for a few minutes to make sure the heat sink in the back wasn’t going to get too hot and melt the back of the fog light holder. It got a little warm but nothing to worry about. After that I put the screws on and snapped the plastic cover back on and was finished. I didn’t even need to adjust the position of the beams. After I installed one light I compared it to the oem one and it was perfectly aligned.Overall I’m very pleased with the results, but wish that they came with instructions explaining that minor modifications might be needed.

The fog lights are nice and bright. The installation is a bit challenging but can be done without removing the front bumper. Time will tell how well they hold up. But initial my impression is they are well built and hopefully will last the life of the vehicle.

Very nice replacement fog lights for my CRV. The beam is nicely spread on the ground horizontally in front and to the sides of me, just below the main low beams. In fact they light the sides to a very wide angle outward without being blinding to on-coming traffic at all. Getting the existing light modules out for replacement wasn’t so easy. But these light fixtures fit nicely to existing trim with only a slight enlargement of one of the lamp tab holes. The lens also seems much more substantial and hopefully resistant to stone impact. Time will tell.

Easy to install super bright at night. Hopefully they last a long time.

It fits really well and provides a large improvement when compared to the OEM unit. The dark housing also makes the car look more modern.