Nantucket SinksUM-15x12-W Oval Ceramic Sink – 15"x12" Undermount Bathroom Sink for Bath Vanity, Small White Bowl, High-Gloss Vitreous China, Scratch & Stain Resistant – Great Point Collection

I had to replace an undermount sink at my home. The previous sink was broken by a dropped perfume bottle. The cut-out in my granite countertops was 14" side-to-side, and 11.5" front-to-back. This sink was as close to perfect as I could find. It left a little overlap of the granite over the edges of the sink, but nothing that would ever be noticed or look bad. The inside of the sink is likely just under 15" side-to-side (~14.75") and right at 11.5" front to back. The finish on the sink is great with no defects, and it comes with the silver plastic trim for the overflow hole (optional to use it or not).I used clear silicone and two pieces of 1"x2" wood to hold the sink under the granite, just like the previous sink was installed. Would definitely buy again if a sink gets broken again, but hopefully don't have to.

I bought two of these to fit a non standard 18" deep double sink master vanity. The area was too narrow for the standard 21" depth. This created a lot of problems including how to get two sinks in that would both fit into the vanity, not make the counter seem too small, and not make it look like we had put children's sinks in our master bath. These fit the bill... barely. We wanted the faucets to be directly behind the sinks instead of off set. We were redoing the bathroom so we took the sinks and faucets in to the granite manufacturer who was doing our counters. In order to get the sinks and faucet in the granite manufacturer who also installed the sinks/faucets had to actually chip 1/2' off of the back lip of the sin,k just enough to allow the faucet to slide by. In the end we are extremely pleased with the size and how the counter came out (see pictures). You should know that the drain is not centered in the bowl, it is recessed back and the bowl angles down to that point to allow water to flow into the drain. This also places the pipes underneath very near the wall. Not a problem for us as we were re-plumbing from one sink to two, but something to be aware of if you are trying to replace an existing sink. For us this was the perfect combination of a narrow front to back size to allow for installation into an 18" vanity with enough bowl depth and width to make it seem like a full sized sink. It can be done! I am very glad I bought them and very glad I didn't try to install it myself.

Sink arrived (box inside of a box) and I was a little worried, but the sink is well seated in Styrofoam. Although I didn't need the template or the under counter mounting hardware, it was all included. The sink cast looks good to me, nice and centered. My only real issue was I purchased this based on the dimensions listed in the description... which, as it turns out, are not accurate. I had a custom piece of furniture being used as a vanity, so it required some modifications to get this sink to work. However, the end result was perfect.For those that want the real dimensions:OD: 17 1/16 x 14 1/8ID (inner edge): 15 1/8 x 12 1/8

The sink arrived on time and in good condition. However, it is not like the original that it replaced.It did not fit the original plumming setup, which required multiple trips to the local DIY to redo the drain connections.The drain hole was in a different location from a top-down view.

Hello all! I was redoing 2 different bathrooms with new quartz countertops and wanted undermount sinks. My installer did not offer this size and this was the best price I could find B&M or otherwise. Sinks were shipped quickly, arrived in great condition and intact. I posted a question about a missing trim piece for the overflow. A Seller replied that they would send one out but did not suggest how I could contact them with my address, since you can't reply to your own question. That's the ONLY issue I have had. Trim piece is not essential but I wanted to have them be the same. It would be helpful if the seller included contact info in the packaging of the sinks!In any case, I would totally buy these again. I saw no problems with the ones we got. Love them.Seller contact info please?

Great value, worked well with my small bathroom cabinet. I would definitely buy again.

They are beautiful sinks and arrived intact but once we started working on installing them, we came across several issues: 1) like another reviewer said, only one of the sinks arrived with the trim piece for the overflow hole 2) only one sink came with a template 3) the Biggest issue was that these sinks were completely out of round. Immediately sent these back and purchased American Standard sinks.

Needed to replace a cracked bath sink for a landlord client. Getting the old one out was by far the worst part - it took several hours and we had to smash it into bits with a hammer and then slowly scrape off all the glue and remaining shards of old sink from underneath the existing vanity - what a chore.This new sink was the exact dimensions as specified and fit back in place perfectly as a replacement, except that the drain location was about an inch different from the old sink, so we had to buy some additional drain pipe parts, in particular a flexible tailpiece, in order to get the new sink to match up to the existing drain. The quality of the sink seemed very good, the lip was level and smooth and glued/clamped into place very easily, and hopefully will last a long time.