ALITOVE24V Power Supply 4A 96W AC/DC Adapter 100-240V AC to DC 24 Volt Converter 4amp 3.75A 3.5A 3.3A 3.2A Transformer 5.5x2.5mm for LED Strip CCTV Camera LCD Monitor Massage Chair

2021-08-08 Increased to 5 starSeller was quick to send me replacement adapters. Just finally got around to the install today.2021-07-02 5:30 PM Increased to 4 starBoth power supplies confirmed working fine. Confirmed it is one bad female adapter connector, and possibly another slightly marginal one. 2nd one gets slightly warm. I would not expect a wire/connector to get warm at all. The one adapter seems to have a short in it. Squeezing ( very gently ) the body of the connector causes LED strip to flicker. Tested both PSUs with both strips and both connectors, connector was the issue. LED strips both OK, PSUs both OK. I have reached out to customer service in regards to the problem connector(s).Also some FYI. Power supplies are barely warm with no load, and according to a watt meter shows 0 watt draw with no load attached. So there is only neglagible loss when the devices connected to it are off. Dim blue LED stays lit when connected to wall power.2021-07-02 4:00 PM 3 - starWill update review as I test more. Connected it on a test bench to a 47 watt light strand. 1/2 the power rating of the PSU. The provided adapter to wire the lights does not make a good connection with the PSU cable end. Additionally, most worrisome, it gets HOT. It was warm after 2 minutes and I disconnected, triple checked polarity/connection fit. Let it all cool down. Reconnected and let it stay connected for 5 minutes. At that point the adapter was too hot to handle comfortably.As for the poor fit, while connected I watch the power draw into the power supply from the wall outlet. It varies greatly, from 22 to 48 watts. If I squeeze the adaptor connector it will make a slightly better connection and go closer to 48 watts. Jiggle it a little and it drops as low as 20, LEDs flicker a bit. Power draw fluctuating. Bypassing that adapter everything seems OK. Note: I have not connected any dimmers/controllers in line, this is just PSU to LED strip for initial testing.I have 2 of everything for this install, I will test with other units / combinations to rule out the problem, but so far it seems to be the little adapter is just no good.

This ALITOVE 24V power supply works exactly as expected. It feels well-built and provides steady power without overheating. I used it for my LED lights, and everything ran smoothly. It’s easy to connect, and I appreciate that it works with a wide input voltage range. If you need a reliable 24V adapter, this is a great choice.

Works great on the Bambu AMS 2 Pro at half the price. Tested overnight drying at 65C with no issues.

Surprised - but this little cord ran our projector PERFECTLY! and for hours!Very pleased with the purchase - and definitely happy to not pay the $84 the office store charged for the same strength cord!

This was a good replacement for my previous one that blew up. Good price and worked well enough. No real complaints

Bought this as a replacement power supply for my red sea reef led 90. Works as advertised.

Good for LEDs or some other load but VERY noisy when used to power audio amp or preamp

Good power source. I have not had any issues with the ones I have used. Good replacements for the price and they last a long time.