Mishimoto 3" Straight Coupler, Red

The blue matches the cold air intake pipe

Great quality

Use this for my intake coupler. My old rubber coupler was busted up leaking air into my throttle body so I had it duct taped for a while. Got this eventually and installed. Works great. Only complaint is that the "HPS" brand flaked off in a day. Literally a day. I tried to sharpie it back on but it looks ghetto. Functionally, it works great though. No more air leaks and it is relatively flexible.

One of the most durable products I have used. And the price is less than the competition. Highly recommend Mishimoto couplers.

I bought these to replace “no name” couplers that were included with my cold air intake. These look much better and seem a lot more durable than the ones i had on before. Solid little couplers, would buy again.

Now this is a great product for the price. I've hadn't had one pop off on me yet even with the basic stainless steel hose clamps and running 8 lb of boost I've yet to see one pop I went ahead and added t-bolt clamps now just add some strength to the hold I give this product to 5 of 5 stars in every way you can most companies are charging 20 to $30 for one silicone coupler. why bother when I can get three for the price of one possibly four this is a great item for the budget builder!!!!

Bought this as a replacement coupler due to misplacing my original coupler.

It's mishimoto that's all I need to say. It was too small for my intake in particular, but its mishimoto. If you don't know by now then that sucks for you

I ultimately wasn't able to use this for what I intended to use it for because it was too long for what I needed, but honestly it felt like a good quality product. the silicon felt sturdy and it didn't feel like it would give out under high pressure. i was going to use it as a coupler for my intercooler on my subaru but didnt feel like cutting it down to size.

Les dimensions sont parfaites très bonne qualité je recommande fortement ce produit

It's soft to the touch and quite flexible. Not a problem though. Has been used to install a custom intake on my Volvo V70R. This goes to a Spectre 90 degree pipe also found on amazon, then to an amazon spectre cold air filter. Withstands about 21psi of boost from a k24 turbo, so does the trick.It's easy to clamp and doesn't require as much force to clamp down because the material is relatively thin. Nice silicone material that won't tear and should stand up to heat. Has been fine since installed. Great price too!

Used these in the past for intake installs. Perfectly fits K&N's 4960 air filter base.

This was probably overkill for the coupling on my ATV transmission breather. Dimensionally accurate and flexible, looks well made with fibre core. Hoping silicone will last where OEM rubber fell apart.