Board Dudes 12" x 12" Light Cork Tiles 4-Pack (70VA-4)

Great tiles, especially for the money involved. They are a little bit thin, but it worked out ok for us because we were putting them up on a recessed area in our wall after covering up an old window. They fit perfectly. We used 6 packs for a rather large area and now our son has a big pinboard in his room to show off his artworks. Exactly what we were looking for.

Plenty of people are complaining about it being too thin and the adhesive pads not working. Luckily it fits my purpose well. Bark for bark scorpions to climb on. I recommend this product for that and nothing else.

In my opinion, these cork tiles were inferior in quality, and possibly just old inventory as they crumbled and broke into pieces when handled. The adhesive strips worked quite well on our new, clean surface - problem was the cork tiles did not adhere to the strips. They would not stick, they fell off and broke into pieces. I returned the 8 boxes (some unopened and unused) and was charged nearly $15 as a restocking fee. How the seller was able to 'restock' broken and crumbling cork tiles is a mystery to me. If I could leave less than a 1 star rating I certainly would. Buyer beware.

The cork is good but it does not stick and they only give you 4 little small pieces of sticky tape for each piece of cork. They are very greedy with tape. Even so, cork and tape do not work together. I am not recommending for this reason. I went to the dollar store and got a large piece of foam board for $1 and used that instead. It works much better. I also got an entire roll of sticky foam tape for $1. So I should have gone there 1st. This was a complete waste of money.

Great price compared to alternatives that I have looked at, and purchased. I am using these to insulate the bottom of the heated bed on my 3D printers. I cut them down to size and clip it to the bottom with the same clip that I use to clip the glass to the top. These are thick enough that they do not sag and create air gaps under the bed. This helps the bed heat evenly and stay heated with minimal effort from the printer. I am using them on 220mm x 220mm and 200mm x 300mm beds.

Very thin. I had to use two pieces and reinforced the back with carboard to ensure that the pins wouldnt go into the wall. I used the box from amazon it came in and cut it to size. My project was for 4 boards so I only got 2 out of this. Very thin and breaks off easy. If you do not plan on covering these witj fabric like I did you might want to go up on quality. This is very flimsy and similiar to the cork under coasters or to keep thinga from sliding.

Two of the boards were in tiny pieces but I think that was due to delivery personnel. The other 2 were easy to put up and are still doing a great job.

Read lots of reviews after I ordered this that didn't sound too good. But this cork board worked for me. I took the suggestion from other reviewers not to rely on their double sided stick tape stuff. I used E6000 and it's not going anywhere. Yes it's thin, but I had these cute fabric covered thumb tacks and regular thumb tacks are perfect. This is on the inside of one of my kitchen cabinets. I am super happy with how they turned out and are working.

They're thinner than I personally expected (about half a thumbtack in thickness), they did not stick to the wall with their sticky tape. Concept was great, the reality was not. I would not buy again, unfortunately.

This was not cork sheets like advertised on the site - it was some kind of hard cardboard/particle board about 1/4 inches thick. Complete waste of my money - could not return it as I opened it late and the return period was closed.