Tesla Model 3 / Model Y Center Console Wrap - Carbon Fiber (Gen 2.0)

So ... this isn't an easy peel and stick .... in order to make it look good you have to be patient and precise in the placement of the wraps ....The order I had came with 2 each and thank god because I destroyed one of them putting it on .... but then on the second try it came out great.The cup holder wrap was extremely difficult to put on but after playing with it over and over ... I got it to where I wantedDid I do it perfect ... pretty sure I didn't ... but on a scale of 1-10 .... I think I did a 9 and it's looks spectacular .... wow !!!!!

Requires a little patience but its possible! Don't rush and read the instructions. The pictures speak for themselves, this cheap upgrade makes the car look a lot more expensive! Its very forgiving, I was able to "lift" and start over whenever I knew my alignment was off. There is a little excess, but it is easy to tuck into the aluminum trim, thank you Tesla for giving us a 1mm gap in the trim (pointing at it in the picture). The part the folds "down" into the console may be prone to "fingers" rub it firmly left and right with your finger and it'll go away.For the cupholder piece, they make you attach a tape film to "guide" it into place which is genius. "Float" it down until the cupholder part aligns and then work from there. Dont be afraid to gently lift if you don't align the first time, this vinyl is forgiving. Afterwards there's a little excess to wrap downwards and it looks great! I can see a 0.1mm gap where I sorta messed up but you gotta be 3 inches away to see it. Overall, worth the money. And they even tell you they'll give you a replacement if you mess up! Would buy from again!!

Cutout not perfect. Wasted 30 minutes or more trying to put this and wasted my money. Very difficult to install. Will not recommend.

Looks way better than expected, loving the new upgraded look.Make sure to follow directions & watch video tutorials before getting started. I am not good at installing things like this, but it was really easy just takes patience. Would also recommend having someone help so one person can hold the wrap up while the other smooths it out. Take your time. Mine came with 2 wraps so if you mess up the first time, you can try again.

Fit was not great. The cutouts around the cup holders are not in the right place. If I line up with the cup holders then it will not cover the front, if you line up with the front edge it will not line up with the cup holders. I could not seem to get the bubbles out. I likely replace it at some point with a different brand.

After watching video, it was very easy to install. However, the first video I watched said to peel the backing partly off and then tear the backing off. This was NOT a good idea because it left a residue on the back of the wrap which came out as a bump when I put the wrap on. I did get a replacement from the seller and redid it with much better results (i.e. not tearing the backing off but peeling it off intact as I applied the wrap). The carbon fiber looks great in a hi-tech Tesla.

The wrap looks good, matches the real carbon fiber dashboard. Only issue I had was keeping the weave straight as I placed the wrap on the console. Also the wrap seems to be a little fragile so don't apply a lot of pressure on the trimmed areas of the wrap,like the cup openings. You can start ripping the carbon texture.

I purchased and installed both the center console and dash wrap! Looks great but I have 2 tips. #1 for the center console cup holder section take the time and pinch the little slivers on the outside of the cup holder then tuck. #2 for the dash, just get a second person and a razor and have them stretch the end then razor the extra material then tuck! I know it was suppose to be exact fit but stretching the material while another person holding was way easier!