FRAM Fresh Breeze Cabin Air Filter Replacement for Car Passenger Compartment w/ Arm and Hammer Baking Soda, Easy Install, CF11776 for Select Infiniti and Nissan Vehicles

This is a great filter. Installation was a royal pain due to Nissan's decision to put the filter housing behind and to the left of the glove box and then run a plastic housing down and just in front of the filter opening. I have never seen a more Rube Goldberg design too for a cabin filter housing. You have to contort you body to get in position to use your fingers to set the opening door and latch it. But the Fram filter was flexible enough to get it into position. Good job Fram.

It’s a filter. Easy to install

This was a bit tricky to install due to the location of it but overall not too bad. You have to compress it like an accordion and put it in the filter slot. A much better alternative than letting the oil change shops doing it for you. They upcharge so much and this is so much cheaper.

Great purchase. Price is could be better. Love the smell it produce in the car. Would purchase again if the price was less.

Perfect fit in my 2018 Nissan Altima SR. Getting the old filter out on this car is a pain in the rear! Getting the new one is easier, but had to scrunch it a little to get it in. This is not a problem with the filter. It's the way Nissan designed and located the access for this. It's on the left side of the passenger floor. Almost behind the center console.

Its not Fram's fault that Nissan horribly designed the cabin air filter box on all there car and truck models. Before I go any further, make sure you note the direction of the airflow when you pull out the old cabin air filter. In the case of the 2016 Nissan Altima, it was pointing towards the cabin and away from the firewall. Not doing this will ruin your air conditioning system overtime. The cabin air filter installed backwards will get clogged up quicker and restrict the air going through the vents more and more overtime. This makes the system work harder and prematurely burn out your blower motor. Get a small flat blade screwdriver to remove the cover if you cannot do it with your fingers. Remove the old filter noting the direction of the air flow. Next grab your new cabin air filter and place in the proper air flow direction. I had to crunch the middle of the cabin air filter element, just to get it back into its compartment. Don't worry if you fold the sides while doing this, it won't rip easily. There's no smooth way to do this, you will be wrestling with this to get it in and most of it will be by feel as its almost impossible to see what your doing. Also the cover will give you a fight when trying to click it back on into its place. Be careful to not break the tab off. After all that struggle and double checking my work I finally finished the installation. I turned on the Altima's air conditioning and right away I smelled the Arm & Hammer and carbon strips neutralizing the air and smelling clean out the AC vents. It is kind of intimating, so watch a couple videos online to give you and idea on what to expect. Good luck.

Worked perfectly to reduce the odor of cigarette smoke. I don’t smoke but this car smelled like a lit cigarrete prior to this filter. Now it smells like a new car

This Fram cabin air filter is good quality, as you expect from Fram and fits the 2016 Nissan Murano. It is a real pain to install, but this reflects on Nissan's design and not on this filter.

It was installed by a Red Seal Mechanic. I watched the process and it was very difficult to install because of the design of my vehicle (Nissan Murano) and not because of the part itself. Nissan must have made this difficult to do so that no one would try it themself. The whole glove compartment had to cone out.

Item as described. Delivered quickly

Good

When I started the engine I really felt the difference! Installation was roughly 15 minutes and saved a fortune when compared to dealership.

Exactement comme l'original