BON AUGURE Industrial Bar Cabinet for Liquor and Gl, Rustic Wood and Metal Wine Rack Table, Accent Sideboard Buffet with Doors (47 Inch, Vintage Oak)

Lo utilizo como cantina es muy bonito me gusto mucho

Works well, went together easily and was not missing hardware. What more can you ask for!

Assembly: I assembled this in about an hour and 15 minutes, and it was really easy. The instructions are well written. I did exactly as they instructed, not tightening any of the main bolts until the very end. I had no problems getting the doors to line up.Capacity: I searched around a long time to find a bar cabinet that would hold a lot of bottles and not just 3 or 4. This thing holds a ton! In the pictures, I have 22 bottles on the bottom shelf and 19 on the top shelf behind the doors! I was amazed I could fit that many.Quality: I was pleasantly surprised that it doesn't look cheap. And it doesn't feel cheap either--the top of the cabinet isn't smooth but has a nice grain feel to the touch. And the back of the cabinet actually shows the grain as well (albeit with one vertical strip of tape), when many similar cabinets would just have bare particle board on the back. The middle shelf in the cabinet doesn't sag at all even holding 19 bottles. It feels very sturdy.Cons: My only criticism is that they don't give you three wine racks, especially because the top shelf has the holes pre-drilled like the center shelf (I have the flat side facing up, but you could easy have the side with the holes facing up and put in another rack if you can find something to fit).Overall, I'm really happy with this piece!

I rather liked the look of this bar from the moment it was suggested to me by Amazon. When I received it, I was a bit intimidated, but assembly wasn't difficult. One thing that most furniture gets wrong (whether it's delivered in a box or not) is door alignment. These doors line up surprisingly well, however, which makes it look that much better. The instructions are very clear, but make sure you read them carefully as there are steps that clearly say you should not fully tighten the screws until a certain point in the assembly process. This is to ensure everything lines up before being tightened down. The wine rack holds 15 bottles, and 6 wine glasses from the hanging racks. It has a great layout, a nice aesthetic, and good storage. I'm impressed.