Mesee 1/4 Inch Shank Flush Trim Pattern Router Bit with Bearings Guide, Top and Bottom Bearing Template Trimming Bit Woodworking Milling Tool - Cutting Height 1-1/2 Inch

Used this to flush up some 22mm MDF panels for a cabinet project. Perfect, clean cutting!Not sure how well it would cope on tougher materials, but for light woods it's great!

Very poor quality, bearings are not a good fit to the shank so there’s lots of vibration. Blades chipped and blunted almost instantly on very soft pine.

Does the job intended

But exploded on first use. Lower bearing shot off causing bit to dig into wood underneath, Ruining my project, before exploding and firing straight at me. Thankfully I am sensible enough to use protective equipment.I DON NOT recommend this product, it is dangerous to use and NOT fit for purpose.

This bit broke off the first time it touched the wood, flying into my arm and puncturing it. I never got to use it.

This tool started off well, sharp and effective. However it kicked back in light use and the spindle bent 30 degrees. The rod was not nearly hard enough!

Used once and it snagged on a piece of 6mm ply and is now out of balance. Time to bin the cutter

The bit would struggle to cut butter absolutely rubbish gone in the bin

Absolutely a perfect piece of garbage. Within 3 ft of cutting, the ring on the bottom comes off. Wow.

Great bit. We use this to cut the edges of some kitchen cabinets smooth. We cut out part of our kitchen cabinets so we could mount two wall ovens.

Bent over on the first pass.