Front Load Washer Tub Bearings and Seal Kit Parts Replacement Compatible with LG & Kenmore Etc-Brown

Simple install, took about 3-4 hours disassembled almost the entire washer. One tool I would recommend if you do this is a bearing puller. The old bearings were frozen in place, I soaked them with WD-40 for 30+ minutes and still pounded them out with a 2lb sledge. new bearing went in easier. The tub shaft was a very tight fit and would have been easier with a puller.Overall way better than shelling out $700+ for a new washer.

This is a great value and good quality parts. Saved a lot of money versus buying individual parts. Washer runs like new. I would definitely recommend this kit!

This is the kind of repair that most services won't do. They just tell you to get a new machine. It was neither easy to remove nor install, but that isn't reflective on the parts but the 80% disassembly of the machine required.The parts were great with one exception. The tub o-ring did not fit as it was about an inch too long. The bearings and seal gasket were perfect.Be prepared for blood and swears.NOTE: 54 weeks after installation the bearings have failed. Gotta start all over again. Not effing happy

The bearings were probably manufactured in the same Asian factory as the rest of them that are available. However, this company doesn't stand behind their marketed version of them very well.I changed the bearings to these bearings 6 months ago. They worked great for a while. But the same noise issue is returning. No warranty. No deal on a new set. Just a response that "The humming sound cannot be determined if it is due to the bearing. It may be caused by other reasons."I'd suggest buying from another company.

We have a 2008 LG washer and it started making a lot of noise. Figured it was either bearings or the spider so I replaced both. Not saying it was an easy job (this is not something I do frequently), but got the job done and washer has been running well for at least several months now.

I installed this set about a year ago with a buddy. About 9 months in they began to make noise, and now a year in they are noisier than the machine shop I work in. I also recall having trouble getting the included gasket to fit properly between the drum halves (so I just reused the existing gasket).Now, I could have just gotten a bad part , so I'm giving these another shot. When I contacted regarding warranty, they asked me for a picture (I don't know about you, but I don't know what a picture would resolve here, nor how I would take a picture without ripping the whole thing apart) - so for twenty bucks I just ordered another set. Maybe I'll follow up for a refund after I replace this next set.I'll try to remember to follow this review up after some time to indicate whether my second set performs better / same / worse, and adjust my rating to suit.

The bearings were out in my fro t load of washer. Bought these bearings as replacement bearings. A little time consuming because you have to take the whole thing apart but the parts worked great & washer works as good as new now. Very happy with product.

Fit perfect

If the old bearings are rusted, it'll take some work to get them out. The new ones are a perfect fit.

Pour réparer laveuse lg

Bearing fit perfectly in the LG tromm washer. The o-ring that connects the two halves of the tub was to large but a razor blade to cut the chunk ,some good glue and I was able to fix the issues. The parts showed up 2-3 days before they were even supposed to be shipped, which helped out and got my washer fixed way faster

The bearings seem like OK quality but are an off shore brand. The rubber gasket was too long for my LG machine so I re-used the old one. The seal fit.My machine is fixed, but this was a big job. The seal location on the washing machine drive shaft was heavily grooved by the old seal, so don't know how long this fix will last as water may get past the new seal and damage the bearings. It it does I will by a new washer, but it won't be an LG POS.