YUMORE 16 inch Stainless Steel Shelf Brackets, Heavy Duty Solid Shelf Support, Max Load: 550lb Corner Brace Joint Right Angle Bracket, Pack of 2

Good Shelving Bracket. I you need a rust resistant bracket this is the one to have, it's made of heavy gauge stainless and is very sturdy once mounted properly to a good piece of wood.

Great for DIY shelving! With the unique removable diagonal support, it's much easier to work with. With other brackets, trying to drill screws in straight can be a pain, the support gets in the way. I'm making wall shelves using 8' 2x12 lumber. With two of these drilled into studs, I was able to sit my full 185 lbs on it with no issue. And the wood itself weighs 53 lbs so you're looking at close to 240 lbs, no problems. I intend to use this shelf for vinyl records which gets heavy, 100 records weighs about 50 lbs if I remember correctly. I intended to use 4 of these on four studs per shelf, but now I'm thinking 2 might just be sufficient as it seems rock solid. But I may do 4 anyway, as that would be completely impervious.Note: I strongly recommend using studs, not trying to hang shelves in just drywall, if there's going to be any weight at all. Also, I didn't use the included screws. I predrilled holes into the center of each stud using a drill (having carefully located the studs with a stud finder, and triple checked the marks), then drilled in self-tapping 2 1/2" #9 star drive screws I purchased separately from a hardware store. Please don't attempt to use Phillips head screws for a similar wood working project - they will want to strip, and you'll be pulling your hair out. I've learned doing my DIY projects that it's worth getting star drive/torx screws. Frankly, Phillips head screws should no longer exist. It's an inferior design, at least for woodworking, and very prone to stripping. Sure, if you pre-drill, are strong enough to keep the screw bit pressed tightly to the screw at all times, and know what you're doing, Phillips will work. But star drive and the like are just fundamentally superior for any project requiring larger/longer screws, and you truly get better results with much less struggle because the bit will tend to stay locked to the screw and not strip the crew, due to the design.Also, to me, these brackets look pretty good. I'll be ordering more to complete my other shelves

very nice sturdy

I purchased these to replace brackets on my boat. I will see how they go during this fishing season. They are stainless steel. I will report back in the fall of 2025 on how they held up during a fishing season. They do look well built and sturdy . Again if I remember I will report back in the fall I 2025

They are perfect. I needed brackets that were sturdy enough for a shelf to hold laundry detergent so i could get everything off of the dryer. The removable gusset made it super easy for me to drive the tapcons and install on a concrete wall. I would definitely buy again.

Heavy-duty, well made.

Loved everything about being able to achieve my vision using these sturdy quality made brackets for my bookshelves!

I used these along with another version to re-enforce a shelf to hold a 65 lb. Electric pressure washer on the wall. I like the fact that to angle brace is removable to allow easy access to mount.