Edge Supply Red Oak 3/4 in x 50 ft Roll – Pre-Glued Iron On Wood Veneer Tape – Wood Veneer Edge Banding Tape with Hot Melt Adhesive, Smooth Sanded Finish Ideal for Furniture & DIY, Made in USA

If there was a finger joint anywhere in this roll, I didn't even see it. The glue adhesion was great, no issues with application and it went on easily. The red oak grain and color looked very good, and the texture was perfect for my application.

It goes on just like it should, it trims easily, it stains and really easy to use. It looks real because it is real more than thick enough that you can sand it and not lose it.

This worked very well. The glue is very sticky with only a quick pass of the iron over the wood. The wood looks good and didn’t have any defects. Easy to trim the edges after installation with a small plane I’ll buy again

We use this in our cabinet shop and find it to be just as good as the non-glued veneer. It is too thin and the glue is all wrong for use in our antique restoration shop but if you are buying this for new-made furniture it is perfectly adequate. Be sure you set your iron hot enough and follow the application with masking tape to hold it firmly in place for a recommended 6 hour cure time before trimming, sanding and finishing. For best finishing results I recommend that you buy cork blocks and rub the veneer firmly once installed and cured to burnish the surface to get the truest most consistent finish and coloration. If you skip this step the wood dyes and finishes will adhere and behave differently giving less than satisfying results. Overall this can be used for all new furniture applications as long as it is applied carefully, cured and grain blended. It’s an excellent product that I recommend for any pre-glued application. There’s a bit of a learning curve but you have lots of veneer on this roll! Practice on some scrap first.

Worked great! It was easy to apply and trim and sand. I have applied about 50 ft of it and have not encountered a joint or flaw yet. The quality of the Red oak is better than other brands I tested. You can see in the video that it's hardly noticeable.

We used a heat gun and hard rubber roller to apply the veneer. With two people, the job went very fast. We had some extra and it was going so well we went crazy and tried covering a small table top with strips butted side to side. I was not very confident, but that also turned out beautiful. We used a sanding block to slightly round-off and blend where two pieces joined on an outside corner. The first piece was trimmed flush with the edge. The second piece was overlapped to the outside edge of the first. Surface prep was a major part of our success. We had stripped many layers of paint using a heat gun followed by a low odor paint remover. The original plan was to stain the wood, but the type of wood just didn't look great. We chose this product based on other reviews and are very happy with the results.

Product as described. Competitive price, fast delivery and great product.

Excellent material

Every thing 100%

Excellent quality and very strong material

Seeing that I am from Australia and the edging comes from the US, it matched the Red Oak plywood perfectly.

EASY TO INSTALL AND TO TRIM. YOU CAN'T ASK FOR MORE. I used Birchwood Casey Tru-Oil gun stock finish on it because you can apply it with your finger so it is not messy. You could use any clear product on it. I just happened to have the stock finish already. Real nice.

Works well and sanded really nicely too