Rust-Oleum 214944 Specialty Reflective Finish Spray, 10 oz

Not as reflective

Expensive, waste of time. This didn't work at all. Only thing it did was give the item a flat finish. Not refractive even using a flashlight

Nice

Havnt got any red light tickets!! Works really damn good. Im impressed. Did 4 layers on 2 plates and 2 layers on buddies plates. Still have half a can left over. Perfect ratios for spraying. Works for evening/night accidental red light squabbles. Update 8/6/25 doesnt work for a accidental red light camera trap during the day. 7/10. Wish there was a revised formula to correct that issue. I now owe $350 Doesnt work for day time

I have wanted reflecting wheels for my bike, but what few are made are very expensive and my bike takes an odd size wheel. When I ran across the listing I was thrilled, but concerned as to whether the paint would work at all because of so many bad reviews. Well, I generally followed the directions on the can and the result is a very reflective wheel rim. Here is what I did: 1) taped off the parts of the wheel where I didn't want paint (obviously). This is a bit of work, but fortunately I was working with the rim only and will build up the wheel later. I used the wheel as a template and cut curves in the blue painters tape so I could mask the machined sidewalks of the rim. 2) shook the can very thoroughly. This is very important because this "paint" is a clear coat carrier for super tiny reflective beads. It is these beads that makes your item reflective, if they are not mixed in to the stream you are spraying at your object, it will not end up reflective! (Think unshaken vinegar and oil dressing.) 3) shook the can again after every 15 seconds of spraying, according to directions. 4) did three very light coats 2 minutes apart. While I was waiting between coats, I kept shaking the can so the reflective beads and the clear coat paint wouldn't separate. After drying, I tested in a dark room and a flashlight and it was definitely reflecting. I noticed that from some parts of the rim (the flats parallel to the ground) were super bright white compared to the rim sidewalls. This can only be from the higher density of beads. This gave me the idea to add more paint. I repeated steps 1-4 after 24 hours. The brightness of the reflectivity increased dramatically. Even the blue painters masking tape is shiny. I may do a third round as an experiment, although my buddy says it looks great already and should stop. I bought another can to do more wheels.

I purchased a can of reflective paint to spray on the arms of my bike rack which extends beyond the bumper by a good foot or so and I am concerned about people driving too close and hitting it - especially when the bike is not on the rack. However, despite spraying at least 7-8 coats, it barely reflects headlights. First I painted the black arms a bright blue and put the reflective paint on top of that. It turned the blue with a hazy white that does not reflect light very well at all. It would have been better just to paint the arms a higher visibility paint and leave it at that.

worked good

A side from waiting a long time for the product to arrive. Whe I used it. I applied it to my address numbers it didn't do anything. Not even a glimmer with a high beam light. Do not buy!

Does not work as described. Reflection is too low.

Used this to spray over the registration plates on my cars , trucks and motorcycles . it is so reflective under standard flash photography , like in the case of say ......photo radar or red light camaras ...... the entire plate reflects with such intensity that the image in unreadable . Use this info as you please :)

100% work No more tickets 🎟️ Hoooooory I will drive as fast as I can 🥫 😍

رديئ

I followed the instructions to the letter. Shook the hell out of the can as instructed, applied thin layers and all it did was make my number plates hazy but definitely not reflective.