Edge Supply Birch 3/4" X 250' Roll of Plywood Edge Banding, Preglued Real Wood Veneer Edging, Flexible Veneer Edging, Easy Application Iron on Edge Banding for Restoration, Made in USA

I've been woodworking for over 30 years and a DIYer for as long as I can remember (starting with my Dad), but I've never used veneer edge banding before. I normally use solid hardwoods, but I have to make ~20 kitchen drawers, so I'm opting for baltic birch plywood instead (for speed and wood stability). After researching a little I opted to get the 3/4" banding for 5/8" plywood. I can always trim off a little, but I can't add. Plus, I wasn't sure if the banding would slide around during the heat transfer phase, which it didn't.The 250' roll was a good deal and was a much better value than the smaller sizes. Of course for me, I have to make ~20 drawers, so I'll go though most of this roll. When the banding arrived I noticed that the sticker said "253 ft.", BONUS. Not a lot, but it's better than getting less. The banding width varied a little, but some of the wider parts were ~0.762" (see photo).I slightly oversized the length that I needed for each drawer side and placed the banding (glue side down, LOL) on the edge of the plywood, trying to center it since the banding was wider than the plywood (by intention). I used our iron (I'll have to get a cheap iron for veneering the rest) and set the temperature just under "wool". I placed the iron on one end and slowly moved it to the other end, then I doubled back a little quicker a few times for good measure. The bond seems really good. I then used a edge banding tool to trim the veneer to the correct size with no issues or tear-outs. I trimmed the ends with a flat cutting pliers, but a chisel would also work well (turn the piece over and push down on the chisel against the end piece of veneer when it's against a solid surface).Overall, I like the veneer and it did a good job.

This just works. No complaints.

First time using this and love it! It's so easy to use and make all my plywood pieces looking beautiful! I used it for 1/2" and 3/4" birch plywood. Would recommend!

Easy to use. Have ordered multiple times

This is the second roll we've ordered through Amazon and we're very pleased with the quality. It's less expensive than ordering through the local lumber yard.

I bought my first edge banding from the big box store. When I needed more, I found the Edge Supply Birch. It is a much better value, and it works better. The glue is thicker and it really holds.

Adding edge wood tape on cabinets