Ford Ignition Switch Lock Cylinder + Pair (2) Door Lock Cylinder W/2 Logo Keys LC6177 + DL5886

Just as the OEM. Came with all the logos on the key and works perfectly.

I recently purchased a 1997 F350 that came with one set of keys and the doors/ignition were mismatched from an ignition swap the previous owner had done. I was looking for a complete set and this one, while not the cheapest offering, included all 3 locks, Ford branded keys, and gaskets for the door locks. The swap is quick and painless. I ended up pulling the door panels to hook attach the door locks because I dropped the rod in the door both times but that wasn’t a big deal.

I had my 2000 Ford Ranger XLT broken into and the people tried to take the truck and ruined the ignition but couldn’t take it. I order this part with the door locks so I would only need one key for the ignition and door locks. It was easy to install (hardest part was getting the broken up old ignition out). You will need new keys that have the transponder in them so the keys that come with the kit won’t work on your vehicle if you have chipped keys. I just went to my local locksmith and they were able to cut me new chipped keys for the ignition and the door locks. Everything works good as it should.

Needed after a local restaurant cleaned the table, including my car keys, and tossed them in the dumpster. Works well but the gasket that comes with the door locks just doesn't fit quite right. Does not affect operation. Keys definitely need to be deburred with a touch to a wire wheel. Everything else fits/works perfectly. Good Price.

I sorely needed a new passenger side door lock since the one on my truck stopped functioning. This set filled my need since I'd have to replace both the door locks and the keyed ignition switch if I didn't want to have to carry around two keys for my truck. The only "problem" was with the lack of instructions. This was the first time I've had to replace the door locks and ignition switch on any vehicle. I had to do some research to learn the easiest way to remove the ignition switch. Also, it would've been helpful to know to soak in water the fiber washers that go between the door lock body and the exterior door surface before trying to place them on the door lock body. I broke the first one I tried to put on the lock body. The second one I soaked in water about a minute before putting it in place and it popped right on without breaking.

This set is perfect. All cylinders fit perfect. Ignition cylinder beauty ring is a little shallow and shows some metal when installed in the column. Not a bother. Just smooth operation and a full. Ford branded set of keys! Like the truck is brand new again. Highly recommend!!

Locks work well, plastic parts didn't even last through installation

Its not made for it but I put these on my 1993 f350. The cylinder for the ignition fits and works perfectly but is not flush (almost unnoticeable). The holes on the door were too small to accept these door cylinders so I had to widen the holes with a file and dremel as well as file some of the metal off the bottom of the new cylinders. The clips that hold the cylinders were able hold the new ones. They all works fine with no wiggle. I rated 5 stars because they worked perfect for my application.