4-pin 12AWG DC Power Supply Cable for Yaesu Radio FT-450D FT-891 FT-991-A FT950 FTDX-1200 Kenwood TS-480 TS-590SG TS-890s Icom IC-7000 IC-7200 IC-7600 IC-7300 Alinco DX-SR9T Vertex

Worked great on my Yaesu FT - 710. I like that it is shorter so I can easily connect to a portable battery. I may add another for my power supply on my desk. The build quality is good and comes with two ring connectors, black and red. Great value.

Definitely as good as the OEM cords on my FT-950 and FT-891. I decided on shorter cables as the ones that came with the rigs are way too long for my shack and I don't use either rig mobile or portable. Those long cables are just getting in the way, look sloppy even bundled up, and get in the way. The ring terminals absolutely do fit the cable. I did trim off another 1/16 of an inch of insulation to make sure I had enough to crimp and solder. I am now able to reorganize my equipment layout without the struggle of cable bundles..nice and tidy.

Works well

These are good enough for an Icom 7300.

I like this one as it is not as long as the original cable, as i mainly want to use it at home with a fixed setup, so i do not need the extra length, and shorter is better in this case. Also the connector fits nicely.

works great

Everything you need in one package to connect your ham radio to a power supply or battery. If you are doing a mobile installation or you are in a large rack, the length may not be enough, but plenty of length for a desktop or portable setup. Comes with 30A fuses so be prepared to swap the fuses per your radio's recommended rating if needed.

Works fine

Satisfactory power cord for alternate power supply but would have preferred heavier wire.