SP-67749 Swivl-Eze Lock'N-Pin Aluminum 7-Inch x 7-Inch Marine Boat 3/4-Inch Pedestal Base

Needed a smaller seat post base to fit the space on a new boat build that I am doing. This fits great between two hatch lids where as the larger one would decrease the hatch lid size more than I wanted. Works great , made , been using Attwood products on boats for years.

Well made, fits good

It does what it should. Was easy to mount and holds the seat well. I used rivnuts to mount it to the bench seat in my Jon Boat and it is solid.

My hubby ordered this for his boat. Very strong. Well made

This was exactly what I thought it would be worked great

I flush mounted 2 of these into a v-hull that I restored. I've seen a couple reviews that help with this but don't go in to detail. The step is 1.5' wide and the stem supports welded in are 2.5" wide. This means you'll need to have a hole that's a little bigger than 2.5' to flush mount. I drilled a 1.5' hole and then routered a cone into the wood seats to allow for the supporting welds additional width. How to flush mount: - If drilling into wood: Drill a 1.5" hole into the surface at a depth of 2.5", then file out a cone shape for the welded supports or drill out a 2.5' wider hole over the first at a depth of only .5' - If drilling into metal or fiberglass: Drill a 2.5' wide hole with a depth of 2.5" The plate itself is about .5' thick. If you want to recess the whole thing into wood like I did. Difficulty in removing the seat post. I've seen a lot of reviews that claim this is extremely difficult and even resulted in broken equipment. I did not have this issue. The friction clamp is secure, yet easy to remove. Once I have the option to upload videos I can show one of me pulling a seat post out with just two fingers. About 30lbs of pressure does it. Overall, these pedestal bases are great. The build is sturdy and it will definitely last. The only issue I have is the challenge to install them. It requires some definite knowledge and additional tools.

no problems so far

Installed in my grizzly 1654 for a seat in the middle of the boat. Easy to install and looks good.

Easy to install. Sturdy as hell and does exactly what it’s intended to do.

Excelente producto y listo para instalarlo en la lancha

The nut was not on straight. I could get it to thread from the other side so it’s wasn’t stripped. Had to hacksaw it off and take it to work to get welded back on. Pain in the rear for $70

Bateau de pêche non tester encoure a voir

Excelente