🔩 Upgrade Your Chainsaw Game!
The AUMEL 52mm Big Bore Top Cylinder End Kit is a comprehensive upgrade solution for Husqvarna chainsaw models 362, 365, 371, 371XP, 372, and 372XP. This kit includes a cylinder piston, spark plug, decompression valve, needle bearing, cylinder base, crankcase gasket, exhaust gasket, intake manifold, intake support, and clamp, ensuring you have all the necessary components for a powerful performance boost. Designed for easy installation, this battery-powered kit is perfect for professionals looking to enhance their chainsaw's capabilities.
| Power Source | Battery Powered |
M**N
Great Big Bore P&C!
The media could not be loaded. I put this on a farmmac 372 I purchased from Amazon as a little experiment. It went in perfectly! The inside of the cylinder looked pretty good! I didn’t find any burs or rough edges in the ports or anything, so I threw it on as it was. Put a decompression plug in it, oiled it up a bit, and she runs great! I’ve put this thing through it for about 2 weeks straight of daily use. Running somewhere between 4-6 tanks a day. Not bad! Will edit review with pictures! Had to trim off some of the top cover to make room for the ignition coil, but it’s great! More power, better low end power too! Great little kit! Might buy another one to port if I can get my metal work down pat!Update: it seems like it’s got better??? I don’t know, but I’ve been cutting with this kit in the saw and it was strong but it seems like it’s gotten stronger! I’m loving it, so much so I posting a video of it cutting! This is some fairly hard, charred outside, sycamore. Not bad at all! Enjoy!
A**R
Pretty nice for the money
Good value, no sharp edges, worked great and fired right up, fit like it should.
T**J
Worked good
Perfect just as described
D**N
Low quality machining of cylinder and cylinder casting, but a complete 52mm 2 ring piston kit
Was not able to remove piston from cylinder with out micro-grinding to clean the damaged thin wall at base of cylinder. Damaged was done at factory when packing into box. Quality control is extremely low for this company. Cylinder head is full of small pits within dome top. Bad casting quality. Material hardness is disappointing after working with material. And after checking piston to cylinder clearance, found cylinder diameter over sized by .002 from normal clearance of air cooled 2 cycle standards. Built in Piston slap upon installation before any use.Will not be installing this kit in my saw.Due to having to grind out piston, not going to request return. Lesson learned here.
B**W
Awesome
Cleaned up the cylinder casting here and there, did a little intake and exhaust polishing. Fully lubed everything assembled it, and it started on the second pull. So far I have no complaints. I'd say it's quality is pretty good for an after market big bore kit.
E**C
5 tanks of gas through it and so far so good.
It was delayed getting here but 5 tanks of gas through it and everything is a-o-k.
M**E
I have used many of these to rebuild and convert to Big bore 76.5cc
This kit adds power and is decent quality in the aftermarket building. I have used several. Check out my utube majorpix channel
Trustpilot
2 days ago
3 weeks ago