International Concepts 30-Inch Tea Table, Unfinished

Solid hardwood, sturdy, easy to put together, great price. I would definitely buy from this company again.I noticed some people were complaining about one leg being shorter than the other. I noticed mine wobbled as well when I first put it together. I had considered putting some padding under one leg as others had mentioned. Then I was instructed by my dad, to slightly loosen all the legs. Then stand the table up on it’s legs, and while pressing down on the table, tighten each leg little by little, working around several times until the screws were all fully tightened. Worked like a charm. 😊I hate MDF, plywood, and particle board. Sometimes they cost as much as solid wood furniture. I refuse to pay the price they want for what I call temporary or disposable furniture, because they just don’t last. I would rather to without.This company on the other hand, is a winner. 😁

Parawood, aka rubberwood, comes from the rubber tree in Asia. It is an inexpensive hardwood used to make low end furniture. It has a tight grain so it doesn’t accept paint well and is resistant to attempts to apply stain. It is prone to rot in humid areas so it is not recommended for outdoor or bathroom use. The rubber tree is used to make latex so rubberwood is not recommended for those with latex allergies.

The table is very well made. I was surprised that it is so sturdy. It is made of solid wood, with a close grain. I used a pre-stain B4 I applied a dark cherry finish, and it came out very nice. I have only 2 minor complaints about the table.1) The table does have a slight wobble if you leave the bottom of the legs bare wood. I used some cushioned felt pads from the hardware store and now it is fine. I had planned to do that anyway, so no problem there.2) After assembly, I found that the tapered hole plugs (these are used to cover the recessed screw heads on 2 sides of the table) were too small for the hole and went all the way into the hole, beyond flush. This occurred on only one of the leg assemblies. The other side was fine. All the plugs seem to be the same so the problem must be the holes were drilled to the wrong diameter (too big). If I find a good way to fix this, I'll update my review. It's not that noticeable to someone casually looking, but I know it is wrong and needs to be fixed. Overall, I'm happy with the table.

This is a beautiful, sturdy little table that I got for holding a gorgeous (but heavy) piece of granite that I use for an end table top. Lots of cute details in the curved legs and arched skirt (not sure if that's what the side pieces for the top are called). I have a small desk by this same company that I love, so I didn't hesitate to get this little side table. I used a low voc wipe on Arm-R-Coat (satin) by General Finishes to get an easy great blonde wood natural finish.

I love this little table. Before I stained the top I went over it with a wet cloth to help open up the wood for stain. This wood doesn't except the stain well, but the water helped open it up more. I did three coats of stain and two coats of paint. Then two coats of poly on top of the stain and one coat of poly on the paint.

This is a perfect size table for what I needed it for. The table is solid wood and it matches perfectly with my dinner table.Also, the delivery was quick and timely.

Nice thick wood, sturdy , will order more

Liked everything. Using as night table for a guest room.