Mechanix WearColdWork™ Original Safety Winter Work Gloves (Large, Black/Grey)

Been through at least 10 normal full beko "cottons" 40⁰c 1200 spin wash cycles now using ineos detergent & detol cleanser, held up well, velcro is still good, phone screen still works & they're somewhat warm with good dexterity (I've successfully wired a 3 pin plug), if it's around 0⁰c they're not really good enough for me but 5-15⁰c Are perfect, haven't tested above this range & that's with a moderate level of exercise (carpentry framing outdoors)

Comfortable warm and water proof - perfect for cold weather work

Bought these to use for my job in security (standing not doing a lot!!) over the colder months. They work pretty well and fit nicely but I would probably opt for something better or a liner inside if the temperature goes below 2-3°c. They are not ECW gloves so probably not designed for below those temps anyway.A major gripe for me is, compared to the regular gloves they make, is the velcro wrist strap is way too large and I always have to over tighten them which makes wearing them uncomfortable in that area. The size of the rest of the glove fits perfectly on my hand though.Good gloves for the job I do. They look good also and I still recommend them despite my previous reservations.

Good qualityWarm

Good sturdy gloves.I am a wheelchair user and these gloves get a bit of abuse but stand up to it well

Passed these on to the Mrs.They fit, but the base of the fingers are far too tight. They pinch.I can't wear these , which is a shame as I have ordered lots of other gloves from them.Only needed a couple mm extra, or even just one mm, but as is, I can't wear.(AMAZON, THE PIC SHOWS THAT I DON'T HAVE WIDE FINGERS, AND THEREFORE THE GLOVES SHOULDNT BE AN ISSUE.)See pic, sauce sachet for comparison... I haven't got fat fingers, so this pinching is surprising.DO I RECOMMEND?sort of, but you'll need extremely thin fingers ... Unlikely as a person who manual stuff.More suited to women's fit, than mens.

Used for just under a month and already falling apart. Haven't used for any hard lifting or rope work, literally just lifting buckets. Started falling apart about 2 weeks ago (week after I started using them) and I've had to use tape to keep the insulation in. I was told this brand made strong gloves but cheap 80p a pair gloves last almost as long. Might be good for cosplaying military or airsofting but not much else.