🚀 Unleash Your Engine's Potential!
The Spectre Performance SPE-9751 Black 4" Air Duct Hose is engineered for performance enthusiasts seeking to enhance their vehicle's intake system. With a memory-flex design, it allows for easy customization and optimal airflow, ensuring your engine breathes better and performs at its peak. Weighing just 0.01 ounces, this lightweight yet durable ducting solution is perfect for any automotive project.
| Manufacturer | Spectre |
| Brand | Spectre |
| Model | K&N - Air Duct Hose Kit (9751) |
| Item Weight | 0.01 ounces |
| Country of Origin | China |
| Item model number | SPE-9751 |
| Is Discontinued By Manufacturer | No |
| Exterior | Machined |
| Manufacturer Part Number | 9751 |
| OEM Part Number | 9751 |
C**E
Worked perfect on my old Chevy
Used for the factory cold air intake on my '88 K5 Blazer. The oem hose is discontinued. Put this one in place of the old tube that was crumbling away. Easy to install and worked perfectly. Will order another one for my '85 Chevy K10. The ends just screw on and your good to go.
D**C
High quality hose and exactly what I needed.
High quality flex tubing. NOT dryer hose or remotely similar to it as a reviewer stated. Ends are a bit difficult to thread on the hose but once correctly installed provide a sealed connection. Add hose clamps to fasten it to your intake and whatever you are pulling air from and you are done. The strength of this product is quite apparent. You can form an S with the hose and it will retain its form while you hold it up. This hose was 41" stretched out before I divided it. I needed 2 hoses so I cut this into two and bought an extra set of couplers. Nice and worth the cost to me.
N**S
Fits my MG Midget 1500
I’ve been looking for years for the heater vent pipe for my midget 1500 and this fit perfectly. The rubber coupling is a little hard to get onto the pipe itself, but slides right off the heater for easy removal (which happens often). Cut to length, pipe is plenty long. It has a steel wire spiral for reinforcement, it’s not just plastic.
W**N
1992 Ford f250
Work perfect going from my factory air intake to my breather on my 92 7.3 IDI NA
T**Y
Good
It fit very good.
R**Y
Can't beat it for the price
The ends screwed on really easy. It stretched very easy and held shape no problem. Just what I needed to get my intake from the carburetor to outside the engine compartment
K**A
Size incorrect
This was made of quality materials, but it measured at 3.75" outside diameter, which is far too small to be used for a 4" throttle body.
V**E
Pretty goo
Not very strong but good enough
Trustpilot
1 month ago
2 weeks ago
