Muzata 20Pack Extension Connector for LED Channel fit Muzata U1SW U101 U107 U108 17MM Width U Shape LED Channel for Longer Connection LCB1

Way easier to use then the ones that come with the tracks. Hate the d@mn screws though. Took 2-3 minutes per trying to install each one because the screws are tiny, don't work on a magnetized drive tip, and don’t bite into the wood surface for 10-20 seconds...if it doesn't fall off first!

I used to attach 6 ft channels for strip lights. They worked great and gave a professional look.

I had never installed the aluminum LED runners before and thought these would help me keep a 13’ run of multiple pieces straight and in-line at the joints. Boy was I right.Although I think the aluminum track pieces I purchased were great, they lacked longer clips such as these. They installed super easy and made my finished run look seamless. The fastening hardware was just right for applying to wood with a small pre-drilled starter hole.I’d buy these again.

We got these to connect pieces of aluminum channel for our under-cabinet lights in the kitchen. They were relatively easy to install and they make a nice connection between channels. Highly recommended!

This came as separate pieces, so the corners are not connected. Instead of getting 10 completed corners, I got 10 pieces, enough to make 5 completed corners (90 degree elbows). The only way I knew how to attach the corners together to form the 90 degree elbow was to glue them. I used JB Weld on the inside, which seems to work pretty good and is totally invisible on the outside. It does have the milky white lens cover that goes with the straight Muzata channel, so that was a bonus that I was not expecting, because the description did not state it came with it. The angles are cut perfect and crisp, and they do form a really tight corner piece. They also send 10 mounting clips which was nice and I needed them all. That all being said, this did for what I was wanting and produced a really clean and professional looking LED lighting solution.

These work very well to connect and hold the aluminum channels. I would recommend using these in lieu of the small flimsy clips that come with the channels. You can cut these in half and install them as you would the small flimsy clips.

Great but out. Also may be difficult to put them on the led strip housing. Tight and tough. Doesn't bent and is strong enough to support the connecting led led strip housing for install. Great buy but be careful. Can cut yourself on them during install. lol oops?

If you can make a 45 degree cut on a straight run aluminum channel and diffuser, you can make these. I can't, but that same inability means I can't line them up well either. In the description '90 degree U-Shape LED Aluminum Channel turning corner connector' I assumed they actually connected together with something like tab 'A into slot B' but that was overly optimistic on my part. There are pre-made angle assemblies that cost more, I just made a mistake of thinking these were more than they were. I dinged a star, not because of my mistake, but because taking 2 and putting them together didn't always make a good 90 degree angle, close but not that much better than I could do myself.