Earthquake XT 1/2 in. Composite Xtreme Torque Air Impact Wrench 1000 ft. lbs

Hubby enjoyed this. Thank you.

Great impact gun for less than the top brands not battery operated its an air gun so not sure why asking me to rate battery life

Using the standard 1/4” connector from the air compressor, hoses, and tools didnt work well enough for me. I bought two 3/8 adaptor kits (with three nipples and quick disconnect each) from harbor freight and replaced the fitting on the compressor and two sides to the air hose and all air tools. The 3/8” adaptor doubled the power of all my air tools and especially for this impact wrench. I was blown away literally lol if you own air tools and this wrench, do the same thing and it can loosen the tightest bolt from my honest opinion

It can easily rip off any bolt I throw at it. I put milton high flow fittings on it and it's been much better since then. I haven't encountered any bolt, even seized, that this impact hasn't been able to take off. It's a must to get high-flow fittings and I'd use at least a 3/8in air hose. It still worked well with a 1/4 hose, but the 3/8 is recommended. Noticeable increase in power with the 3/8th. Bought it from harbor freight a few years ago for $90 and don't regret it 1 bit. The price listed is too high in my opinion.

I bought this at Harbor Freight. I know they are not known for top quality but this is absolute junk. It would not budge lug nuts that my far lower rated gun does. Do not buy it.Update: When I originally bought this I thought it didn’t work. I later found my compressor had a slight leak and didn’t give enough air. It now works good.

This impact gun is very strong. All the people that are saying that this is weak I guarantee that you have the improper fittings on this. This REQUIRES the use of high flow fittings. If you use the standard fittings this thing will feel dead and have no power and struggle to take off lug nuts. After purchasing Harbor Freight high flow 1/4 fittings with a 3/8 air line this impact gun came to life and was able to remove 110 ft lbs lug nuts in a fraction of a second. I use it on tougher rusted nuts on a Dodge Ram 2500 probably torqued to about 350 ft lbs and it was able to remove it like it was nothing. If the gun feels weak then its not the gun but its your air source.

I have a 30 gal 10hp 130 PSI compressor. Even with all that, this impact still could not spin off a lug nut. It was driving me insane. After digging around, I learned about "high flow" air fittings. Harbor Freight makes some, or you can get some here. They flow twice the air of the standard fittings and big air tools like this impact REQUIRE them in order to function. I bought a set of 10 fittings, put one on this thing and within a 10th of a second the lugs were off. Didn't even make this thing breath hard.Get high-flow fittings if this thing isn't giving you the torque you want.

I have no clue what people are talking about. I am a tech and use this gun all day everyday and have zero issues with it. My only complaint is that the trigger is rather stiff. Other than that this gun performance just as good as snap on or mac. Do not listen to the people saying there junk. I put mine through heck and high water and it always comes out on top!