🔧 Snap into Action with Precision!
The 6Pcs V-153-1C25 Micro Limit Switch features a long straight hinge lever arm and is designed for SPDT snap action. With a robust rating of 15A and compatibility with Arduino, this pack of six switches is perfect for both hobbyists and professionals looking to enhance their electronic projects.
D**K
Well-made Limit switches
I had the most commonly found limit switches on my cnc. The little metal arms always fell off. So, when I built my new machine, I wanted better made switches.I the new configuration of the machine necessitated longer arms. I tried arms with rollers, but they didn't quite work out. I bought these. The arms are a lot better made than they look in the photos.To work properly on my controller, I had to wire 2 switches (on the same axis) to work on one plug. I'm using female spades on each end of the wires so I can easily disconnect the switches when needed. I've wired the switches to be normally closed.They work great and are a huge upgrade over most switches.
D**T
Taito Ice Cold Beer replacement bar switch
These switches are exact replacements for the original, Taito Ice Cold Beer coin op game. Will require a custom bend on the switch arm but screw holes and all other geometry are an exact match.
D**S
WYSIWYG
It is what it is
M**A
Solid feel, positive vlick
Very good switch on 1st use. I replaced a broken anti-tip microswitch in a small heater. It matched the position of the old switch perfectly. I had to cut the lever to fit its smallish compartment, but they're made long, so there was plenty of arm left for it to function as needed. This switch can be wired for "normally open" (NO) or "normally closed" (NC), depending on your need and which connector you use. The spring is fairly strong, and I was concerned that the weight of the heater wouldn't be enough to keep it in it's "closed", or NC position, but it was perfect, and I like the positive feel and audible click. It's reassuring that it's doing what it needs to do.I didn't want to toss the heater for this minor issue and the price made it cost effective to resurrect it. Perfect solution.
"**"
Still at work
Likes: Small, lightweight, versatile. It never failed after years of daily use in a low voltage system.Dislikes: None
K**L
Work as intended, used as CNC Limit Switches
I bought these to use as limit switches for my hobby CNC machine (Sainsmart Genmitsu 3018 if anyone's interested). I did end up heating the huge switch levers up enough to soften the plastic and pulling them out so my machine directly contacts the buttons for a little more precision, but they work as advertised. It's been a huge QoL upgrade for me being able to home my machine to facilitate repeatability and tool changes across a single job.
J**D
good design
I like the long arm. It makes positioning the switch easier. I bought them to install in my gun safe with just some inexpensive under the counter type lights. But they have gotten expensive. By sheer luck I found a gun safe light kit by Stack-on at Sportsman Warehouse that was being discontinued by them. I will keep the switches because they appear well made and will come in handy elsewhere.
H**Y
Works but noisy and takes considerable pressure to actuate.
Price Is good. They work but make a very audible click sound. Its also takes a lot of pressure for a micro switch to actuate. Not a Problem for my Use. But could be for others. If you are used to usa made units. ... Omicron etc these take 10 times the force to actuate. And it 'clicks". So if that matters then dont buy it. I cant dpeak about life. Its new and im passing a lovolt signal only
Trustpilot
2 months ago
2 weeks ago
