Replacement Antenna for Sennheiser EW100G2/100G3 Wireless Microphone/IEM Bodypack Transmitter Receiver,Frequency Covered 450-970MHz

Near ideal replacement. The antenna mounts as the originals do, but connect to the circuit board via wire pigtail not the metal tab of the original. Signal strength and reception level at least as good as original (tested vv a twin unit.)

It's a perfect fit

works great, easy to swap out the old antenna with the new one. You will just need a soldering iron and a screw driver (with the proper tips).

Just replaced two worn-out antennae on two Sennheiser in-ear receivers. This antenna works (tested it last night at a gig) but installation needed a bit of trickery. The original has a short end of the antenna that's just long enough to be soldered onto the motherboard. This replacement antenna has a much longer wire (about 1/2"). You could probably cut it, but I managed to wrap it into a loop and shove it between the two PCBs inside the bodypack. So it's possible to use it without modification, but you have to be careful not to pinch it when reassembling the unit. Also, make sure when you take the bodypack apart to keep an eye on the "SET" and "ESC" plastic buttons. They like to fall out and roll away. Ask me how I know. Just a tip!

Works perfect as a body pack antenna replacement

These are garbage. Will not help reception with Sennheiser G3 or G4 lavs. I ordered a few from Sennheiser and they worked perfect. These do not work at all.

We carefully followed the installation instructions and these had terrible noise and interference. Then we ordered the brand name replacement with frequencies specified and low and behold, it did work. Save your money and avoid these.