LIGHTEU Seaflo Automatic Submersible Bilge Water Pump for Boats 12V Car with Float Switch 1100GPH

EXCELENTE

Die Seaflow Pumpen sind top. Wir haben sie manuell und automatisch angeschlossen. Sie haben einen Testmodus, Rädchen drehen, dann geht der Schwimmer hoch, dann kann man dieses in regelmäßigen Abständen auch testen. Klare Kaufempfehlung

Works perfectly. Does not say anywhere that it to is automatic. Cables are a little too short, be prepared to extend with connector block and marine sealant unless your bilge is less than 1/2 metre below your power supply. To connect to a float switch for "automatic" use just connect neutral to neutral of cheap float switch which for convenience you can connect to unit with simple elastic band. Personal Tip.(prob not best practice but..) .connect ends to a mains plug with a nice long lead and thicker mains wire. Then you can use a simple mains plug switch (about 1.50ukp) connected to your battery (with a blade fuse inline) which is easier than most dc switches and can be used thereafter for multiple 12v sources without rewiring etc .. Of course you better mark it 12 volt only otherwise I leave results to your imagination. I have very very dirty bilge with silt and rocks .. Unit has been perfectly clean and clear everytime I checked. The Head is only 1.5 to 2m so for some applications you may need to extend hose down below bilge to get it going.

Gewoon goed

tried to use it to pump out rain water from a electric motor pit installed below ground. just a toy meant for max 1 to 2 feet of lifting height. my requirement was 4 feet and it was too less efficient and needed replacement.