STAR BRITETeak Sealer - No Drip, No Splash Formula - One-Coat, Durable Protection for All Fine Woods - Perfect for Outdoor Furniture & Marine Use - Natural Light 16 OZ (087916)

Great stuff...very easy to use. Restored my shower teak bench. Not too orangey.

Great finish and sealant for the AquaTeak benches and shelves. I bought the 16oz pint of "Natural Light" tinted sealer and fully sealed (before assembly) all surfaces of an AquaTeak 30" Maluku Bench with Shelf and an AquaTeak 15.5" Kai Corner Bench with Shelf.The picture shows how much was left after fully sealing both benches I mentioned above. So a little goes a long way.

It is very good provided the furniture is 100% cleaned and stripped. Simple to use, color (natural) is the perfect teal tone and the protection from fading is great. Two coats are needed to get the best coverage. I used large car sponge and cut it up which works better vs other methods.Cons- way too expensive for this little size which did two chairs, one side table.Semco is a better product IMO but higher proved and tougher to find

Although some reviewers say it turned their teak orange, I found that not to be the case. It does have a tint that is warm, but a pleasing look if you don’t want the silvery weathering look, or want to delay it. A quart goes a long long way if you apply it thin, with just the slightest dab on a foam brush. I still have a little left after sealing a loveseat, chair, ottoman and two side tables. The furniture in my photos are new, one month old under a pergola, and the loveseat was unboxed and assembled the day of sealing. They all look the same after sealing, whether a month of exposure or right out the box. The wood will chew up foam brushes quickly so buy a half dozen, or a brush or two per pieces of furniture. I have no comment on longevity since I just applied it but it is easy to work with, nice and thin, and I like the look. It does take a while to cure, maybe a couple full days of direct sunlight, so be patient and make sure its cured before you put cushions on it.

Bought this to refinish an old rocking chair because I was too lazy to completely strip off the old varnish. It worked perfectly!

We used it for old teak furniture, we power washed and sanded 1st. You only need a small amount. Get absorbed well and seemed to give the pieces a fresh look. It's easier to clean now.

I used this on an unfinished teak table top I bought to use outdoors on my patio. The wood was already sanded and clean, and I just applied this product with a foam brush. I bought a 4 inch wide brush that didn't fit into the can - I should have bought a 2 inch wide brush. It went on so easily. I left it out in the sun for one afternoon to cure and it was already essentially dry and ready to use. Some reviewers complained it is too orange. If you apply a thin coating, like you are supposed to, it brings out the color of the wood without being orange. If you lay it on too heavy and end up with blobs of extra product pooling on your wood, then yes, it will look orange! Be moderate in how much you put on your brush, inspect the area you have just applied it to, and adjust the amount you put on the brush as necessary. If you have a few blobs of orange on the area where you just applied, just use your brush to spread the extra away onto an area that hasn't been treated yet.

The sealer went on well enough, but took way longer to dry/cure than I was led to believe in the instructions.Even after being in direct sunlight for 4-5 hours, then 2 hours the next day, the wood I treated stayed tacky for about a week until it finally began to get to a point where I could buff it lightly with a lint-free cloth. Then it finally got a good sheen to it.