BUDI Pop-up Design 30 Slots Memory Card Case Crush & Shockproof Wallet for 27 Micro SD SDXC SDHC TF Cards and 6 Cards/Micro SDHC/Micro Holder Organizer,Case Storage

Small and compact. Quite sturdy feeling, has space for 2 Sim cards a must for travelers. Comes with a lanyard. Micro SD cards are a bit difficult to remove but also very secure.

High quality for the price. Convenient. Take a minute to get used to, but very helpful organizing SD and micro-SD cards.

This is the sort of thing that you can pretty much look at the listing and know exactly what you're getting, and thus also the sort of thing that I wouldn't normally bother leaving a review for because my review would just be "does what it says on the tin, five stars"... *if* it didn't have one glaring issue. But, well, it does... It is virtually impossible to prevent it from producing *some* amount of high-pitched squealing or screeching every time you slide the card holder out, similar to the sound produced by rubbing two pieces of styrofoam against each other. (If you don't find this sound viscerally unpleasant, I envy you.) This is because both the inner card holder piece and the inner liner of the body that it slides in are made of plastic (presumably the same plastic since the description mentions only the one type, although the card holder has a matte finish while the inner liner is glossy). On top of this, the slide mechanism consists of small channels in the inner liner that mate with small ridges on the faces of the card holder piece, with no additional stabilization of the card holder--no rails down the sides or anything of the sort. This means that the card holder piece moves pretty freely when you slide it in or out, and can bind against the inner plastic liner--never so much that it gets stuck completely, but enough that the friction creates the rubbing-styrofoam-together squealing sound. This is why I bothered to write a review, and why I rated it only four stars. Insofar as I have any other complaints they're basically ones I saw from other reviewers: - SD card slots are a little loose and microSD card slots are a little tight, so it's almost too easy to remove SD cards and slightly harder than it needs to be to remove microSD cards—I find that I have to remove them by pushing from the “front” of the card, that is, the smaller end that gets inserted into a device, rather than pulling on the wider back part where there's the ridge for grip/leverage. But this is a minor inconvenience at worst. - The wrist strap channel is engineered in such a way that it's very difficult to actually insert the strap. Again, a minor inconvenience at worst since I’m not going to be removing and reattaching it repeatedly.

Its a super nice, strong build and i feel very good about it protecting my SD and Micro SD cards, the only thing taking one star away is it kinda locks my SD cards in funky. They can fall out when its open and i feel like im fighting to get em out sometimes. Definitely my go to right now though and I would recommend buying it.

It was good in the beginning but was getting broken later on

I like the concept of this memory storage case. It holds a significant number of both SD and Micro SD cards, but it comes across as being cheap and of low quality. First, I find that the cards tend to fit rather loosely, causing me concern that I might lose a card(s) if I'm not paying close attention when it is open. In addition, when sliding the storage compartment open it squeaks badly as the internal plastic compartment rubs against the metal housing. It gets the job done, but it gives the impression of being of low quality.

I decided to buy this storage device after enjoying a previous BUDI SD card reader of the same, but smaller design. This baby is all storage so you can your mini-SD cards, SD adapters/cards in an easy to slide out metal case. Even comes with a Pin that has its own storage spot for card removal. And finally a pull out tray for holding your phone on the bottom. The last image also shows my first BUDI purchase of the card reader and storage that I already love and use often. I highly recommend getting this product as it's durable, shock resistant and compact... Meaning easy to store and travel friendly.

For the price, this works great, but there are some things I don't like about this. The precision of the SD slots are not precise enough. I could use the same SD card in each SD slot of the case, and there will be different give or wiggle space in each slot. So, there are some SD slots that I just don't use because my SD cards slide out with just opening the case. All the MicroSD card slots fit perfectly, and the case stays shut tightly and opens smoothly.

The lid of this holder doesn’t work because it’s size bigger that body! It can’t hold the normal-sized SD card! Bad quality and I highly recommend NOT to buy this!

El estuche se siente de buen material, es compacto y práctico.

A very NEAT way to STORE SD and TIF Cards including MICRO Cards

Excelente