330 Wire Flush Cutters (Pack of 2), Electronic Model Sprue Wire Clippers, Ultra Sharp and Precision CR-V Side Cutting nippers, Ideal for Clean Cut and Precision Cutting Needs

These worked well to cut the plastic part of the Cat 6A cabling. Being able to quickly cut the plastic out, makes it easier to add the Ethernet connectors. Overall these seem to be really good quality, but I did put a small tight rubber band on it to keep it closed when dropping it in my pocket. Sharp and easy to cut accurately and nice overall design.

If you're here for affordable side cutters / nippers for GUNPLA or other plastic minis... you're in the right place and can ignore the negative reviews. As of 4/12/25 almost every negative review is from somebody that didn't understand the use cases for this product and misused it.I won't exaggerate and call these fantastic, They don't cut as cleanly as a nicer set and can discolor the plastic, but they still work well enough to get the job done.*For those that don't know what GUNPLA/ or minis are; you're likely looking at the wrong product for your needs and should probably move on and continue shopping elsewhere. These are intended for plastic sprues and very thin and soft wire only. THEY WILL BREAK if used on any other materials.

They work well, are comfortable to use and comes at a great price. They cut clean and the loose piece doesn’t fly across the room. They have potential to last some time.

Works perfectly.

Not Anything fancy, but real sharp and real pointy. Kinda thin blades would not cut any steel or anything like that but good for little copper and tie straps.

these things are nice and sharp for precision 3d prints support removal

Nice set of flush cutters.

These flush-cutters work beautifully, and appear to be well-made. Be careful though, they're for soft metal and other materials ONLY. Made the mistake of trying to cut a thin piece of what turned out to be a steel wire, and ruined the tips. My fault, no fault of the cutters. Bought another and kept the damaged one to check the material I want to cut; if they don't get damaged (again), I'll go ahead and use the new ones.